A compact, efficient and high-power laser diode （LD） single-end-pumped Nd：YVO4 laser with continuous-wave emission at 1342 nm is reported. With a single crystal single-end-pumped by fibre-coupled LD array, an outpu...A compact, efficient and high-power laser diode （LD） single-end-pumped Nd：YVO4 laser with continuous-wave emission at 1342 nm is reported. With a single crystal single-end-pumped by fibre-coupled LD array, an output power of 7.36W is obtained from the laser cavity of concave-convex shape, corresponding to an optical-to-optical efficiency of 32.8%. The laser is operated in TEM00 mode with small rms amplitude noise of 0.3%. The influences of the Nd concentration, transmissivity of the output mirror and the cavity length on the output power have been studied experimentally.展开更多
A theoretical model to simulate an end-pumped CW Nd^3＋：GdVO4 laser at 1063 nm is presented. Its essence is to use the propagation equations to demonstrate the spatial evolutions of the pump and the laser powers in t...A theoretical model to simulate an end-pumped CW Nd^3＋：GdVO4 laser at 1063 nm is presented. Its essence is to use the propagation equations to demonstrate the spatial evolutions of the pump and the laser powers in the cavity, hence it is applicable to both low and high gain lasers. The simulation results obtained by this model are in good agreement with the experimental observations reported in the literature for a Ti：sapphlre-pumped Nd^3＋：GdVO4 laser. Moreover, some parameters, such as the reflectivity of output coupler, the spot size of laser beam and the crystal length, are discussed with a view to optimizing the laser performance.展开更多
A fiber-coupled laser-diode （LD） end-pumped Nd：GdVO4 slab continuous-wave （CW） 912-nm laser and an LD bar end-pumped Nd：GdVO4 slab CW 912-nm laser are both demonstrated in this paper. Using the fiber-coupled LD ...A fiber-coupled laser-diode （LD） end-pumped Nd：GdVO4 slab continuous-wave （CW） 912-nm laser and an LD bar end-pumped Nd：GdVO4 slab CW 912-nm laser are both demonstrated in this paper. Using the fiber-coupled LD of end-pumped type, a highest CW 912-nm laser output power of 10.17 W is obtained with a high optical to-optical conversion efficiency of 24.6% and a slope efficiency of 34.5%. The measured M2 factors of beam quality in x and y directions are 5.3 and 5.1, respectively. Besides, an LD bar of end-pumped type is used to realize CW 912-nm laser output, which has the advantages of compactness and low cost. When the pump power is 38.8 W, the output power is 8.87 W and the measured M^2 factors of beam quality in x and y directions are 16 and 1.31, respectively. In order to improve the beam quality of the 912-nm laser at x direction, a new quasi-concentric laser resonator will be designed, and an LD bar end-pumped Nd：GdVO4 slab high-power CW 912-nm TEM00 laser will be realized in the future.展开更多
The intrinsic features involving a circularly symmetric beam profile with low divergence, planar geometry as well as the increasingly enhanced power of vertical-cavity surface-emitting lasers （VCSELs） have made the ...The intrinsic features involving a circularly symmetric beam profile with low divergence, planar geometry as well as the increasingly enhanced power of vertical-cavity surface-emitting lasers （VCSELs） have made the VCSEL a promising pump source in direct end bonding to a solid-state laser medium to form the minimized, on-wafer integrated laser system. This scheme will generate a surface contact pump configuration and thus additional end thermal coupling to the laser medium through the joint interface of both materials, apart from pump beam heating. This paper analytically models temperature distributions in both VCSEL and the laser medium from the end thermal coupling regarding surface contact pump configuration using a top-emitting VCSEL as the pump source for the first time. The analytical solutions are derived by introducing relative temperature and mean temperature expressions. The results show that the end contact heating by the VCSEL could lead to considerable temperature variations associated with thermal phase shift and thermal lensing in the laser medium. However, if the central temperature of the interface is increased by less than 20 K, the end contact heating does not have a significant thermal influence on the laser medium. In this case, the thermal effect should be dominated by pump beam heating. This work provides useful analytical results for further analysis of hybrid thermal effects on those lasers pumped by a direct VCSEL bond.展开更多
A diode-end-pumped Nd：YAG dual-wavelength laser operating at 1319 and 1338 nm is demonstrated. The maximum average output power of the quasi-continuous wave linearly polarized dual-wavelength laser is obtained to be ...A diode-end-pumped Nd：YAG dual-wavelength laser operating at 1319 and 1338 nm is demonstrated. The maximum average output power of the quasi-continuous wave linearly polarized dual-wavelength laser is obtained to be 2.1 W at a repetition rate of 50 kHz with an output power instability of less than 0.38% and beam quality factor M^2 of 1.45. Using the two lines, the highly coherent and narrow linewidth terahertz radiation of 3.23 THz can be generated in an organic 4-N, N-dimethylamino-methyl-stilbazolium tosylate （DAST） crystal. Meanwhile, the multi-wavelength red laser at 659.5, 664 and 669 nm is generated by frequency doubling and sum frequency processes in a lithium triborate （LBO） crystal. The average red laser output power is enhanced up to 1.625 W at a repetition rate of 15 kHz with an output power instability of better than 0.53% and beam quality factor M^2 of 6.05. Using the three lines, it is possible to generate the multi-wavelength THz radiation of 3.3, 3.43 and 6.73 THz in an appropriate difference frequency crystal.展开更多
AIM:To investigate the preventive effects of low-dose proton-pump inhibitors(PPIs) for upper gastrointestinal bleeding(UGIB) in end-stage renal disease.METHODS:This was a retrospective cohort study that reviewed 544 p...AIM:To investigate the preventive effects of low-dose proton-pump inhibitors(PPIs) for upper gastrointestinal bleeding(UGIB) in end-stage renal disease.METHODS:This was a retrospective cohort study that reviewed 544 patients with end-stage renal disease who started dialysis at our center between 2005 and 2013.We examined the incidence of UGIB in 175 patients treated with low-dose PPIs and 369 patients not treated with PPIs(control group).RESULTS:During the study period, 41 patients developed UGIB, a rate of 14.4/1000 person-years.The mean time between the start of dialysis and UGIB events was 26.3 ± 29.6 mo.Bleeding occurred in only two patients in the PPI group(2.5/1000 person-years) and in 39 patients in the control group(19.2/1000 person-years).Kaplan-Meier analysis of cumulative non-bleeding survival showed that the probability of UGIB was significantly lower in the PPI group than in the control group(log-rank test, P < 0.001).Univariate analysis showed that coronary artery disease, PPI use, anti-coagulation, and anti-platelet therapy were associated with UGIB.After adjustments for the potential factors influencing risk of UGIB, PPI use was shown to be significantly beneficial in reducing UGIB compared to the control group(HR = 13.7, 95%CI:1.8-101.6; P = 0.011).CONCLUSION:The use of low-dose PPIs in patients with end-stage renal disease is associated with a low frequency of UGIB.展开更多
文摘A compact, efficient and high-power laser diode （LD） single-end-pumped Nd：YVO4 laser with continuous-wave emission at 1342 nm is reported. With a single crystal single-end-pumped by fibre-coupled LD array, an output power of 7.36W is obtained from the laser cavity of concave-convex shape, corresponding to an optical-to-optical efficiency of 32.8%. The laser is operated in TEM00 mode with small rms amplitude noise of 0.3%. The influences of the Nd concentration, transmissivity of the output mirror and the cavity length on the output power have been studied experimentally.
基金supported by the National Natural Science Foundation of China (Grant No 10104009)
文摘A theoretical model to simulate an end-pumped CW Nd^3＋：GdVO4 laser at 1063 nm is presented. Its essence is to use the propagation equations to demonstrate the spatial evolutions of the pump and the laser powers in the cavity, hence it is applicable to both low and high gain lasers. The simulation results obtained by this model are in good agreement with the experimental observations reported in the literature for a Ti：sapphlre-pumped Nd^3＋：GdVO4 laser. Moreover, some parameters, such as the reflectivity of output coupler, the spot size of laser beam and the crystal length, are discussed with a view to optimizing the laser performance.
文摘A fiber-coupled laser-diode （LD） end-pumped Nd：GdVO4 slab continuous-wave （CW） 912-nm laser and an LD bar end-pumped Nd：GdVO4 slab CW 912-nm laser are both demonstrated in this paper. Using the fiber-coupled LD of end-pumped type, a highest CW 912-nm laser output power of 10.17 W is obtained with a high optical to-optical conversion efficiency of 24.6% and a slope efficiency of 34.5%. The measured M2 factors of beam quality in x and y directions are 5.3 and 5.1, respectively. Besides, an LD bar of end-pumped type is used to realize CW 912-nm laser output, which has the advantages of compactness and low cost. When the pump power is 38.8 W, the output power is 8.87 W and the measured M^2 factors of beam quality in x and y directions are 16 and 1.31, respectively. In order to improve the beam quality of the 912-nm laser at x direction, a new quasi-concentric laser resonator will be designed, and an LD bar end-pumped Nd：GdVO4 slab high-power CW 912-nm TEM00 laser will be realized in the future.
文摘The intrinsic features involving a circularly symmetric beam profile with low divergence, planar geometry as well as the increasingly enhanced power of vertical-cavity surface-emitting lasers （VCSELs） have made the VCSEL a promising pump source in direct end bonding to a solid-state laser medium to form the minimized, on-wafer integrated laser system. This scheme will generate a surface contact pump configuration and thus additional end thermal coupling to the laser medium through the joint interface of both materials, apart from pump beam heating. This paper analytically models temperature distributions in both VCSEL and the laser medium from the end thermal coupling regarding surface contact pump configuration using a top-emitting VCSEL as the pump source for the first time. The analytical solutions are derived by introducing relative temperature and mean temperature expressions. The results show that the end contact heating by the VCSEL could lead to considerable temperature variations associated with thermal phase shift and thermal lensing in the laser medium. However, if the central temperature of the interface is increased by less than 20 K, the end contact heating does not have a significant thermal influence on the laser medium. In this case, the thermal effect should be dominated by pump beam heating. This work provides useful analytical results for further analysis of hybrid thermal effects on those lasers pumped by a direct VCSEL bond.
基金supported by the National Basic Research Program of China (Grant No 2007CB310403)the Tianjin Municipal Primary application and Frontier Technology Research Plan,China (Grant No 07JCYBJC06200)
文摘A diode-end-pumped Nd：YAG dual-wavelength laser operating at 1319 and 1338 nm is demonstrated. The maximum average output power of the quasi-continuous wave linearly polarized dual-wavelength laser is obtained to be 2.1 W at a repetition rate of 50 kHz with an output power instability of less than 0.38% and beam quality factor M^2 of 1.45. Using the two lines, the highly coherent and narrow linewidth terahertz radiation of 3.23 THz can be generated in an organic 4-N, N-dimethylamino-methyl-stilbazolium tosylate （DAST） crystal. Meanwhile, the multi-wavelength red laser at 659.5, 664 and 669 nm is generated by frequency doubling and sum frequency processes in a lithium triborate （LBO） crystal. The average red laser output power is enhanced up to 1.625 W at a repetition rate of 15 kHz with an output power instability of better than 0.53% and beam quality factor M^2 of 6.05. Using the three lines, it is possible to generate the multi-wavelength THz radiation of 3.3, 3.43 and 6.73 THz in an appropriate difference frequency crystal.
基金Supported by Grant from Hallym University Medical Center Research Fund
文摘AIM:To investigate the preventive effects of low-dose proton-pump inhibitors(PPIs) for upper gastrointestinal bleeding(UGIB) in end-stage renal disease.METHODS:This was a retrospective cohort study that reviewed 544 patients with end-stage renal disease who started dialysis at our center between 2005 and 2013.We examined the incidence of UGIB in 175 patients treated with low-dose PPIs and 369 patients not treated with PPIs(control group).RESULTS:During the study period, 41 patients developed UGIB, a rate of 14.4/1000 person-years.The mean time between the start of dialysis and UGIB events was 26.3 ± 29.6 mo.Bleeding occurred in only two patients in the PPI group(2.5/1000 person-years) and in 39 patients in the control group(19.2/1000 person-years).Kaplan-Meier analysis of cumulative non-bleeding survival showed that the probability of UGIB was significantly lower in the PPI group than in the control group(log-rank test, P < 0.001).Univariate analysis showed that coronary artery disease, PPI use, anti-coagulation, and anti-platelet therapy were associated with UGIB.After adjustments for the potential factors influencing risk of UGIB, PPI use was shown to be significantly beneficial in reducing UGIB compared to the control group(HR = 13.7, 95%CI:1.8-101.6; P = 0.011).CONCLUSION:The use of low-dose PPIs in patients with end-stage renal disease is associated with a low frequency of UGIB.
