The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated vol...The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated voltage. According to the realistic conditions of test stations in China, a control device based on pre-arcing current detection and phase control is proposed in this paper. A sample of the control device made up of DSP TMS320LF2407A is fabricated, in which the CPLD MAX7064 is used to transmit signals for EMC design. It can be applied in full voltage synthetic making test at a level of 126kV/63kA. The test results show that, it is accurate to control the making phase of the applied voltage, whether the closing is demanded at voltage peak or zero.展开更多
The current–phase relations of a ring-trapped Bose–Einstein condensate interrupted by a rotating rectangular barrier are extensively investigated with an analytical solution. A current–phase diagram, single and mul...The current–phase relations of a ring-trapped Bose–Einstein condensate interrupted by a rotating rectangular barrier are extensively investigated with an analytical solution. A current–phase diagram, single and multi-valued relation, is presented with a rescaled barrier height and width. Our results show that the finite size makes the current–phase relation deviate a little bit from the cosine form for the soliton solution in the limit of a vanishing barrier, and the periodic boundary condition selects only the plane wave solution in the case of high barrier. The reason for multi-valued current–phase relation is given by investigating the behavior of soliton solution.展开更多
Powder in tube process（PIT） was adopted for the fabrication of single filament Bi-2223 tapes, and a heat treatment process including the first heat treatment（HT1）, intermediate rolling（IR）, and second heat treat...Powder in tube process（PIT） was adopted for the fabrication of single filament Bi-2223 tapes, and a heat treatment process including the first heat treatment（HT1）, intermediate rolling（IR）, and second heat treatment（HT2） was performed. The phase evolution mechanism and microstructure changes during these heat treatment processes were systematically discussed. The influences of HT1 parameters on the phase evolution process of Bi-2223 tapes were discussed. With the optimized HT1 process, a proper Bi-2223 content of about 90% was achieved. HT2 process was also optimized by adding a post annealing process. An obvious increase of current capacity was obtained due to the enhancement of intergrain connections. Single filament Bi-2223 tapes with the critical current of Ic-90 A were fabricated with the optimized sintering process.展开更多
Polycrystalline La0.67Ba0.33MnO3 bulk samples were annealed in flowing 95%Ar：5%H2 （AH） mixed gas at 973 K for different time respectively. The influence of the annealing time on the current-voltage properties was s...Polycrystalline La0.67Ba0.33MnO3 bulk samples were annealed in flowing 95%Ar：5%H2 （AH） mixed gas at 973 K for different time respectively. The influence of the annealing time on the current-voltage properties was systematically investigated. Linear current-voltage characteristics were observed in the as-prepared and the 10 h annealed samples, and nonlinear current-voltage characteristics was found in the 100 h annealed sample. At the same time, segregation of impurity phase and micro-cracks were found on the surfaces of the 100 h annealed samples, which was testified to be Ba ion impurity. Analysis showed that the changes of electronic properties were caused by barium ion im-purities and micro-cracks in the 100 h annealed sample.展开更多
According to the characteristics of single-phase circuits and demand of using active filter for real-time detecting harmonic and reactive currents, a detecting method based on Fryze＇s power definition is proposed. Th...According to the characteristics of single-phase circuits and demand of using active filter for real-time detecting harmonic and reactive currents, a detecting method based on Fryze＇s power definition is proposed. The results of theoretical analysis and simula- tion show that the proposed method is effective in realtime detecting of instantaneous harmonic and reactive currents in single-phase circuits. When only detecting the total reactive currents, this method does not need a phase-locked loop circuit, and it also can be used in some special applications to provide different compensations on the ground of different requirements of electric network. Compared with the other methods based on the theory of instantaneous reactive power, this method is simple and easy to realize.展开更多
To investigate the affect of direct current electric field (DCEF) on the interfacial phase,in this paper,a hydrophobic ionic liquid (HIL)/water as liquid-liquid two-phase binary system is established by using the deio...To investigate the affect of direct current electric field (DCEF) on the interfacial phase,in this paper,a hydrophobic ionic liquid (HIL)/water as liquid-liquid two-phase binary system is established by using the deioned water and l-butyl-3-methyl imidazolium hexafluorophosphate,and the topographies of the HIL nanodroplets and nanolayers in ambient water are observed by atomic force microscope (AFM).The results show the AFM exerting the DCEF can enhance the intersolubility of the HIL/water binary system and induce their interfacial phase transfer.展开更多
针对双有源桥(dual active bridge,DAB)电路在电动汽车充放电能量转换过程中存在的传输效率低的问题,文中提出一种结合微分极值法与分段控制的最小电流应力优化控制策略。该策略在满足软开关约束的前提下,优化电流应力与抑制回流功率,...针对双有源桥(dual active bridge,DAB)电路在电动汽车充放电能量转换过程中存在的传输效率低的问题,文中提出一种结合微分极值法与分段控制的最小电流应力优化控制策略。该策略在满足软开关约束的前提下,优化电流应力与抑制回流功率,从而有效提升传输效率。首先,以功率正向传输为例,推导拓展移相(extended phase shift,EPS)控制在两种工作模态下实现开关管软开关的条件,并分析回流功率的产生机理,阐述减小电流应力对抑制回流功率的作用;然后,基于微分极值法推导最小电流应力的最优移相比组合,并结合不同模态下软开关范围进行分段控制;最后,实验结果表明,在电压传输比大于1时,该最小电流应力优化策略在全功率范围内实现所有开关管软开关的同时,可以有效降低电流应力、抑制回流功率、提升传输效率。在电压传输比小于1时,该策略虽仍可降低电流应力,但并不能实现所有开关管零电压开通。展开更多
文摘The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated voltage. According to the realistic conditions of test stations in China, a control device based on pre-arcing current detection and phase control is proposed in this paper. A sample of the control device made up of DSP TMS320LF2407A is fabricated, in which the CPLD MAX7064 is used to transmit signals for EMC design. It can be applied in full voltage synthetic making test at a level of 126kV/63kA. The test results show that, it is accurate to control the making phase of the applied voltage, whether the closing is demanded at voltage peak or zero.
基金Project supported by the National Natural Science Foundation of China(Grant No.11874247)the National Key Research and Development Program of China(Grant Nos.2017YFA0304500 and 2017YFA0304203)+1 种基金PCSIRT,China(Grant No.IRT-17R70)the Program of State Key Laboratory of Quantum Optics and Quantum Optics Devices,China(Grant No.KF201703)
文摘The current–phase relations of a ring-trapped Bose–Einstein condensate interrupted by a rotating rectangular barrier are extensively investigated with an analytical solution. A current–phase diagram, single and multi-valued relation, is presented with a rescaled barrier height and width. Our results show that the finite size makes the current–phase relation deviate a little bit from the cosine form for the soliton solution in the limit of a vanishing barrier, and the periodic boundary condition selects only the plane wave solution in the case of high barrier. The reason for multi-valued current–phase relation is given by investigating the behavior of soliton solution.
基金Funded by the National Natural Science Foundation of China(No.51472206)the National ITER Program of China(2015GB115001)the Program for Innovative Research Team in Shaanxi Province(No.2013KCT-07)
文摘Powder in tube process（PIT） was adopted for the fabrication of single filament Bi-2223 tapes, and a heat treatment process including the first heat treatment（HT1）, intermediate rolling（IR）, and second heat treatment（HT2） was performed. The phase evolution mechanism and microstructure changes during these heat treatment processes were systematically discussed. The influences of HT1 parameters on the phase evolution process of Bi-2223 tapes were discussed. With the optimized HT1 process, a proper Bi-2223 content of about 90% was achieved. HT2 process was also optimized by adding a post annealing process. An obvious increase of current capacity was obtained due to the enhancement of intergrain connections. Single filament Bi-2223 tapes with the critical current of Ic-90 A were fabricated with the optimized sintering process.
基金supported by the National Natural Science Foundation of China (10975103)
文摘Polycrystalline La0.67Ba0.33MnO3 bulk samples were annealed in flowing 95%Ar：5%H2 （AH） mixed gas at 973 K for different time respectively. The influence of the annealing time on the current-voltage properties was systematically investigated. Linear current-voltage characteristics were observed in the as-prepared and the 10 h annealed samples, and nonlinear current-voltage characteristics was found in the 100 h annealed sample. At the same time, segregation of impurity phase and micro-cracks were found on the surfaces of the 100 h annealed samples, which was testified to be Ba ion impurity. Analysis showed that the changes of electronic properties were caused by barium ion im-purities and micro-cracks in the 100 h annealed sample.
文摘According to the characteristics of single-phase circuits and demand of using active filter for real-time detecting harmonic and reactive currents, a detecting method based on Fryze＇s power definition is proposed. The results of theoretical analysis and simula- tion show that the proposed method is effective in realtime detecting of instantaneous harmonic and reactive currents in single-phase circuits. When only detecting the total reactive currents, this method does not need a phase-locked loop circuit, and it also can be used in some special applications to provide different compensations on the ground of different requirements of electric network. Compared with the other methods based on the theory of instantaneous reactive power, this method is simple and easy to realize.
基金Supported by the National Basic Research Program of China (973 Program No. 2007CB936000)the National Natural Science Foundation of China(No.10874198,90923002,21073222 and 10975175,No. 10874030)the Chinese Academy of Sciences (No. KJCX2-EW-N03)
文摘To investigate the affect of direct current electric field (DCEF) on the interfacial phase,in this paper,a hydrophobic ionic liquid (HIL)/water as liquid-liquid two-phase binary system is established by using the deioned water and l-butyl-3-methyl imidazolium hexafluorophosphate,and the topographies of the HIL nanodroplets and nanolayers in ambient water are observed by atomic force microscope (AFM).The results show the AFM exerting the DCEF can enhance the intersolubility of the HIL/water binary system and induce their interfacial phase transfer.
文摘针对双有源桥(dual active bridge,DAB)电路在电动汽车充放电能量转换过程中存在的传输效率低的问题,文中提出一种结合微分极值法与分段控制的最小电流应力优化控制策略。该策略在满足软开关约束的前提下,优化电流应力与抑制回流功率,从而有效提升传输效率。首先,以功率正向传输为例,推导拓展移相(extended phase shift,EPS)控制在两种工作模态下实现开关管软开关的条件,并分析回流功率的产生机理,阐述减小电流应力对抑制回流功率的作用;然后,基于微分极值法推导最小电流应力的最优移相比组合,并结合不同模态下软开关范围进行分段控制;最后,实验结果表明,在电压传输比大于1时,该最小电流应力优化策略在全功率范围内实现所有开关管软开关的同时,可以有效降低电流应力、抑制回流功率、提升传输效率。在电压传输比小于1时,该策略虽仍可降低电流应力,但并不能实现所有开关管零电压开通。
