The optimum bleaching parameters (clay dose and bleaching time) for palm kernel oil were determined using alkaline activated clay locally sourced in Nigerian. Activation was carried out using NaOH and KOH. The raw and...The optimum bleaching parameters (clay dose and bleaching time) for palm kernel oil were determined using alkaline activated clay locally sourced in Nigerian. Activation was carried out using NaOH and KOH. The raw and activated clay samples were characterized using XRD and XRF. Bleached oil was analyzed for % colour reduction (%CR) and percentage free fatty acid (FFA) content before and after bleaching. Alkaline activation resulted to total dissolution of Mg2+ and Ca2+ ions in the octahedral sheet. The activation also affected the tetrahedral sheet by reducing the % composition of the silica and alumina ion after the modification. The results showed that alkaline activation had significant effect on mineralogical and chemical composition of the clay samples. The optimum bleaching conditions (clay dosage and bleaching time) of 3%/weight of oil and 30 mins resulted in 33.3% CR and %FFA of 2.2. It was discovered that NaOH activated clay resulted to higher %CR while KOH activated clay shows affinity for reduced %FFA but at higher concentration of 5 M. This research has further established that alkaline activated clays are feasible alternative for acid activated clays in vegetable oil bleaching.展开更多
In this work we determine the physical and mechanical properties of local composites reinforced with papaya trunk fibers (FTP) on one hand and particles of the hulls of the kernels of the garlic (PCNFA) in the other h...In this work we determine the physical and mechanical properties of local composites reinforced with papaya trunk fibers (FTP) on one hand and particles of the hulls of the kernels of the garlic (PCNFA) in the other hand. The samples are produced according to BSI 2782 standards;by combining fibers and untreated to polyester matrix following the contact molding method. We notice that the long fibers of papaya trunks improve the tensile/compression characteristics of composites by 45.44% compared to pure polyester;while the short fibers improve the flexural strength of composites by 62.30% compared to pure polyester. Furthermore, adding fibers decreases the density of the final composite material and the rate of water absorption increases with the size of the fibers. As regards composite materials with particle reinforcement from the cores of the winged fruits, the particle size (fine ≤ 800 μm and large ≤ 1.6 mm) has no influence on the Young’s modulus and on the rate of water absorption. On the other hand, fine particles improve the flexural strength of composite materials by 53.08% compared to pure polyester;fine particles increase the density by 19% compared to the density of pure polyester.展开更多
Bio-glycerol was synthesized from Cameroon palm kernel oil (PKO) through the transesterification procedure. Palm kernel oil extracted from palm kernel seeds using mechanical expression and solvent extraction was purif...Bio-glycerol was synthesized from Cameroon palm kernel oil (PKO) through the transesterification procedure. Palm kernel oil extracted from palm kernel seeds using mechanical expression and solvent extraction was purified and characterized by physico-chemical methods and used in the transesterification process to give biodiesel and bio-glycerol. The biodiesel was purified and characterized as reported in previous articles. Our focus in this article is on glycerol, an important by-product of the transesterification process which has potential pharmaceutical, cosmetic and engineering applications. The bio-glycerol was purified by acidification and the purified glycerol was subjected to physical and chemical characterization. The specific gravity of glycerol was obtained as 1.2 kg/L, viscosity at 40°C gave 1500 cSt and 500 cSt at 100°C;pH was 7.4;the flash point was 160°C, and the ASTM color was 2.0 before purification and zero after purification. The sulfur content was 0.016%w/v. This sulfur content is low thus posing no environment threat. The chemical composition of the synthesized bio-glycerol determined using IR spectroscopy and gas chromatography-mass spectrometry (GC-MS) confirmed the known chemical structure of glycerol. The purification and analysis of bio-glycerol is important as it can find applications in the pharmaceutical, cosmetic and food industries inter alia.展开更多
以槟榔果仁为试材,经pH6.8磷酸缓冲溶液(PBS)提取多酚氧化酶(PPO)粗酶液,采用(NH4)2SO4分级沉淀后,进一步通过DEAE-Sepharose Fast Flow和Phenyl Sepharose 6 Fast Flow柱层析,获得PPO纯化酶液。经鉴定其纯度达到电泳纯,相对分子质量为2...以槟榔果仁为试材,经pH6.8磷酸缓冲溶液(PBS)提取多酚氧化酶(PPO)粗酶液,采用(NH4)2SO4分级沉淀后,进一步通过DEAE-Sepharose Fast Flow和Phenyl Sepharose 6 Fast Flow柱层析,获得PPO纯化酶液。经鉴定其纯度达到电泳纯,相对分子质量为29.2 ku。在此基础上,对提取的PPO进行酶学特性研究,结果表明,槟榔果仁中PPO最适温度为20℃,最适pH为7.0;以邻苯二酚为底物,该酶的最大反应速度(Vmax)为140.84 U/mL·min,Km为3.22 mmol/L。展开更多
文摘The optimum bleaching parameters (clay dose and bleaching time) for palm kernel oil were determined using alkaline activated clay locally sourced in Nigerian. Activation was carried out using NaOH and KOH. The raw and activated clay samples were characterized using XRD and XRF. Bleached oil was analyzed for % colour reduction (%CR) and percentage free fatty acid (FFA) content before and after bleaching. Alkaline activation resulted to total dissolution of Mg2+ and Ca2+ ions in the octahedral sheet. The activation also affected the tetrahedral sheet by reducing the % composition of the silica and alumina ion after the modification. The results showed that alkaline activation had significant effect on mineralogical and chemical composition of the clay samples. The optimum bleaching conditions (clay dosage and bleaching time) of 3%/weight of oil and 30 mins resulted in 33.3% CR and %FFA of 2.2. It was discovered that NaOH activated clay resulted to higher %CR while KOH activated clay shows affinity for reduced %FFA but at higher concentration of 5 M. This research has further established that alkaline activated clays are feasible alternative for acid activated clays in vegetable oil bleaching.
文摘In this work we determine the physical and mechanical properties of local composites reinforced with papaya trunk fibers (FTP) on one hand and particles of the hulls of the kernels of the garlic (PCNFA) in the other hand. The samples are produced according to BSI 2782 standards;by combining fibers and untreated to polyester matrix following the contact molding method. We notice that the long fibers of papaya trunks improve the tensile/compression characteristics of composites by 45.44% compared to pure polyester;while the short fibers improve the flexural strength of composites by 62.30% compared to pure polyester. Furthermore, adding fibers decreases the density of the final composite material and the rate of water absorption increases with the size of the fibers. As regards composite materials with particle reinforcement from the cores of the winged fruits, the particle size (fine ≤ 800 μm and large ≤ 1.6 mm) has no influence on the Young’s modulus and on the rate of water absorption. On the other hand, fine particles improve the flexural strength of composite materials by 53.08% compared to pure polyester;fine particles increase the density by 19% compared to the density of pure polyester.
文摘Bio-glycerol was synthesized from Cameroon palm kernel oil (PKO) through the transesterification procedure. Palm kernel oil extracted from palm kernel seeds using mechanical expression and solvent extraction was purified and characterized by physico-chemical methods and used in the transesterification process to give biodiesel and bio-glycerol. The biodiesel was purified and characterized as reported in previous articles. Our focus in this article is on glycerol, an important by-product of the transesterification process which has potential pharmaceutical, cosmetic and engineering applications. The bio-glycerol was purified by acidification and the purified glycerol was subjected to physical and chemical characterization. The specific gravity of glycerol was obtained as 1.2 kg/L, viscosity at 40°C gave 1500 cSt and 500 cSt at 100°C;pH was 7.4;the flash point was 160°C, and the ASTM color was 2.0 before purification and zero after purification. The sulfur content was 0.016%w/v. This sulfur content is low thus posing no environment threat. The chemical composition of the synthesized bio-glycerol determined using IR spectroscopy and gas chromatography-mass spectrometry (GC-MS) confirmed the known chemical structure of glycerol. The purification and analysis of bio-glycerol is important as it can find applications in the pharmaceutical, cosmetic and food industries inter alia.
文摘以槟榔果仁为试材,经pH6.8磷酸缓冲溶液(PBS)提取多酚氧化酶(PPO)粗酶液,采用(NH4)2SO4分级沉淀后,进一步通过DEAE-Sepharose Fast Flow和Phenyl Sepharose 6 Fast Flow柱层析,获得PPO纯化酶液。经鉴定其纯度达到电泳纯,相对分子质量为29.2 ku。在此基础上,对提取的PPO进行酶学特性研究,结果表明,槟榔果仁中PPO最适温度为20℃,最适pH为7.0;以邻苯二酚为底物,该酶的最大反应速度(Vmax)为140.84 U/mL·min,Km为3.22 mmol/L。
