This paper reports the theoretical study of combining Z-scan technique with Gauss-Bessel （GB） beams beside a phase object （PO） to measure the third-order nonlinear susceptibility components. By using this method, ...This paper reports the theoretical study of combining Z-scan technique with Gauss-Bessel （GB） beams beside a phase object （PO） to measure the third-order nonlinear susceptibility components. By using this method, the sign of refractive index which depends on the shape of the close aperture Z-scan curve can be easily determined. Meanwhile, the magnitude of nonlinear coefficients can also be deduced by theoretical fit. The proposed method is advantageous for high sensitivity and imposes a lower stress in the cases of fragile materials, since small pulse energy is enough for the measurement of nonlinear coefficients. Predictions of the models are compared with Gaussian Z-scan measurement and GB Z-scan measurement. By using GB beams with a PO, the sensitivity of Z-scan measurements is found to be a factor of over 60 times greater than for Gaussian beams and 2 times greater than for Gaussian-Bessel beams.展开更多
Z-source inverter can boost the voltage of the DC-side, allow the two switches of the same bridge arm conducting at the same time and it has some other advantages. The zero-sequence current flows through the fourth le...Z-source inverter can boost the voltage of the DC-side, allow the two switches of the same bridge arm conducting at the same time and it has some other advantages. The zero-sequence current flows through the fourth leg of the three-phase four-leg inverter so the three-phase four-leg inverter can work with unbalanced load. This paper presents a Z-source three-phase four-leg inverter which combines a Z-source network with three-phase four-leg inverter. The circuit uses simple SPWM modulation technique and the fourth bridge arm uses fully compensated control method. The inverter can maintain a symmetrical output voltage when the proposed scheme under the unbalanced load.展开更多
Topological phase transition in a single material usually refers to transitions between a trivial band insulator and a topological Dirac phase, and the transition may also occur between different classes of topologica...Topological phase transition in a single material usually refers to transitions between a trivial band insulator and a topological Dirac phase, and the transition may also occur between different classes of topological Dirac phases.It is a fundamental challenge to realize quantum transition between Z_2 nontrivial topological insulator（TI） and topological crystalline insulator（TCI） in one material because Z_2 TI and TCI have different requirements on the number of band inversions. The Z_2 TIs must have an odd number of band inversions over all the time-reversal invariant momenta, whereas the newly discovered TCIs, as a distinct class of the topological Dirac materials protected by the underlying crystalline symmetry, owns an even number of band inversions. Taking PbSnTe_2 alloy as an example, here we demonstrate that the atomic-ordering is an effective way to tune the symmetry of the alloy so that we can electrically switch between TCI phase and Z_2 TI phase in a single material. Our results suggest that the atomic-ordering provides a new platform towards the realization of reversibly switching between different topological phases to explore novel applications.展开更多
Reaction of polystyrene-supported lithium selenide with 3-acetoxy-2-methylene-alkanoates afforded the corresponding allyl selenide resins and subsequent cleavage from the polymer by treating with methyl iodide to furn...Reaction of polystyrene-supported lithium selenide with 3-acetoxy-2-methylene-alkanoates afforded the corresponding allyl selenide resins and subsequent cleavage from the polymer by treating with methyl iodide to furnish （Z）-allyl iodides in good yields and high purities. The polymeric selenium reagent can be regenerated and reused. So it is a environmentally benign reagent.展开更多
文中提出将新型的三相Z源逆变器应用于永磁同步发电机PMSG(permanent magnet synchronous generator)风力并网发电系统中,分析了此系统下的风能最大功率点跟踪MPPT(maximum power point tracking)原理。阐明了三相Z源逆变器直通占空比...文中提出将新型的三相Z源逆变器应用于永磁同步发电机PMSG(permanent magnet synchronous generator)风力并网发电系统中,分析了此系统下的风能最大功率点跟踪MPPT(maximum power point tracking)原理。阐明了三相Z源逆变器直通占空比和发电机输出转速之间的关系,并设计了基于最大功率曲线的MPPT算法。该算法可省去风速和转速的测量,降低了系统的成本。利用计算机仿真绘图说明了系统做MPPT的工作点调节过程。最后的实验证实了理论分析和算法的正确法。展开更多
基金supported by the National Natural Science Fundation of China (Grant No. 90922007)
文摘This paper reports the theoretical study of combining Z-scan technique with Gauss-Bessel （GB） beams beside a phase object （PO） to measure the third-order nonlinear susceptibility components. By using this method, the sign of refractive index which depends on the shape of the close aperture Z-scan curve can be easily determined. Meanwhile, the magnitude of nonlinear coefficients can also be deduced by theoretical fit. The proposed method is advantageous for high sensitivity and imposes a lower stress in the cases of fragile materials, since small pulse energy is enough for the measurement of nonlinear coefficients. Predictions of the models are compared with Gaussian Z-scan measurement and GB Z-scan measurement. By using GB beams with a PO, the sensitivity of Z-scan measurements is found to be a factor of over 60 times greater than for Gaussian beams and 2 times greater than for Gaussian-Bessel beams.
文摘Z-source inverter can boost the voltage of the DC-side, allow the two switches of the same bridge arm conducting at the same time and it has some other advantages. The zero-sequence current flows through the fourth leg of the three-phase four-leg inverter so the three-phase four-leg inverter can work with unbalanced load. This paper presents a Z-source three-phase four-leg inverter which combines a Z-source network with three-phase four-leg inverter. The circuit uses simple SPWM modulation technique and the fourth bridge arm uses fully compensated control method. The inverter can maintain a symmetrical output voltage when the proposed scheme under the unbalanced load.
基金Supported by the Major State Basic Research Development Program of China under Grant No 2016YFB0700700the National Natural Science Foundation of China(NSFC)under Grants Nos 11634003,11474273,61121491 and U1530401+1 种基金supported by the National Young 1000 Talents Plansupported by the Youth Innovation Promotion Association of CAS(2017154)
文摘Topological phase transition in a single material usually refers to transitions between a trivial band insulator and a topological Dirac phase, and the transition may also occur between different classes of topological Dirac phases.It is a fundamental challenge to realize quantum transition between Z_2 nontrivial topological insulator（TI） and topological crystalline insulator（TCI） in one material because Z_2 TI and TCI have different requirements on the number of band inversions. The Z_2 TIs must have an odd number of band inversions over all the time-reversal invariant momenta, whereas the newly discovered TCIs, as a distinct class of the topological Dirac materials protected by the underlying crystalline symmetry, owns an even number of band inversions. Taking PbSnTe_2 alloy as an example, here we demonstrate that the atomic-ordering is an effective way to tune the symmetry of the alloy so that we can electrically switch between TCI phase and Z_2 TI phase in a single material. Our results suggest that the atomic-ordering provides a new platform towards the realization of reversibly switching between different topological phases to explore novel applications.
基金the National Natural Science Foundation of China （No. 20562005） NSF of Jiangxi Province （No. 0620021） for financial support.
文摘Reaction of polystyrene-supported lithium selenide with 3-acetoxy-2-methylene-alkanoates afforded the corresponding allyl selenide resins and subsequent cleavage from the polymer by treating with methyl iodide to furnish （Z）-allyl iodides in good yields and high purities. The polymeric selenium reagent can be regenerated and reused. So it is a environmentally benign reagent.
文摘文中提出将新型的三相Z源逆变器应用于永磁同步发电机PMSG(permanent magnet synchronous generator)风力并网发电系统中,分析了此系统下的风能最大功率点跟踪MPPT(maximum power point tracking)原理。阐明了三相Z源逆变器直通占空比和发电机输出转速之间的关系,并设计了基于最大功率曲线的MPPT算法。该算法可省去风速和转速的测量,降低了系统的成本。利用计算机仿真绘图说明了系统做MPPT的工作点调节过程。最后的实验证实了理论分析和算法的正确法。
