A vector control based on the extended equivalent circuit and virtual circuits is proposed for the single-phase inverter.By the extended circuit,the other two phase voltages can be extended by the output voltage of th...A vector control based on the extended equivalent circuit and virtual circuits is proposed for the single-phase inverter.By the extended circuit,the other two phase voltages can be extended by the output voltage of the single-phase inverter so as to construct the voltage vector.The voltage outer-loop is to control the voltage vector in dq coordinate system,and the output voltage can track the target value without deviation in steady state.By designing the virtual circuit,the voltage inner-loop can achieve approximate decoupling and improve the dynamic response under the changeable load.Compared with the traditional dual closed-loop control,the proposed dual closed-loop control scheme only needs to detect and control the voltage without the current.It not only can achieve good control effect,but also reduce the complexity of the hardware.Finally,the simulation and experimental results show that the single-phase inverter has good static and dynamic characteristics regardless of stable load or changeable load.展开更多
This paper addresses the problem of selecting a route for every pair of communicating nodes in a virtual circuit data network in order to minimize the average delay encountered by messages. The problem was previously ...This paper addresses the problem of selecting a route for every pair of communicating nodes in a virtual circuit data network in order to minimize the average delay encountered by messages. The problem was previously modeled as a network of M/M/1 queues. Agenetic algorithm to solve this problem is presented. Extensive computational results across a variety of networks are reported. These results indicate that the presented solution procedure outperforms the other methods in the literature and is effective for a wide range of traffic loads.展开更多
A virtual cathode oscillator （VCO） with a resonant cavity is presented and investigated numerically and theoretically, and its efficiency and stability are enhanced. An equivalent circuit method is introduced to ana...A virtual cathode oscillator （VCO） with a resonant cavity is presented and investigated numerically and theoretically, and its efficiency and stability are enhanced. An equivalent circuit method is introduced to analyze the resonant cavity com- posed of anode foil and feedback annulus, and a theoretical expression for the fundamental mode frequency of the resonant cavity is given. The VCO is investigated in detail with a particle-in-cell method. We obtain the microwave frequencies from simulation, theoretical expression, and relative references, and draw three important conclusions. First, the microwave fre- quency is a constant when the diode voltage is changed from 588 kV to 717 kV. Second, the fluctuation of the microwave frequency is very small when the AK gap is changed from 1.2 cm to 1.6 cm. Third, the microwave frequency agrees with the theoretical result. The relative error, which is calculated according to the theoretical and simulation frequencies, is only 1.7%.展开更多
单相开路故障的五相永磁同步电机(permanent-magnet synchronous motor,PMSM)采用有限集模型预测转矩和磁链控制(finite-control-set model predictive torque and flux control,FCS-MPTFC)策略,存在转矩脉动大、价值函数的权重系数整...单相开路故障的五相永磁同步电机(permanent-magnet synchronous motor,PMSM)采用有限集模型预测转矩和磁链控制(finite-control-set model predictive torque and flux control,FCS-MPTFC)策略,存在转矩脉动大、价值函数的权重系数整定困难、迭代计算量大以及共模电压(commonmode voltage,CMV)高等问题。为此,该文提出一种简化FCS-MPTFC策略。首先,建立五相PMSM在单相开路故障情况下的数学模型,并分析CMV产生的机理。其次,以抑制3次谐波电流的原则合成等幅值虚拟电压矢量(virtual voltage vector,V^(3)),并将转矩和磁链价值函数等效转化为电压价值函数,同时采用无差拍控制思想计算出参考电压矢量,进而通过合理划分扇区,直接获得最优V^(3)。最后,选择方向相反的两个基电压矢量代替零矢量,以减小开路故障下的CMV。仿真和实验结果表明:所提控制策略不仅能抑制单相开路故障导致的转矩脉动、降低计算负荷和CMV、抑制电流谐波,而且具有优良的稳态和动态性能。展开更多
基金This work was supported in part by the National Natural Science Foundation of China under Grant 61773006.
文摘A vector control based on the extended equivalent circuit and virtual circuits is proposed for the single-phase inverter.By the extended circuit,the other two phase voltages can be extended by the output voltage of the single-phase inverter so as to construct the voltage vector.The voltage outer-loop is to control the voltage vector in dq coordinate system,and the output voltage can track the target value without deviation in steady state.By designing the virtual circuit,the voltage inner-loop can achieve approximate decoupling and improve the dynamic response under the changeable load.Compared with the traditional dual closed-loop control,the proposed dual closed-loop control scheme only needs to detect and control the voltage without the current.It not only can achieve good control effect,but also reduce the complexity of the hardware.Finally,the simulation and experimental results show that the single-phase inverter has good static and dynamic characteristics regardless of stable load or changeable load.
文摘This paper addresses the problem of selecting a route for every pair of communicating nodes in a virtual circuit data network in order to minimize the average delay encountered by messages. The problem was previously modeled as a network of M/M/1 queues. Agenetic algorithm to solve this problem is presented. Extensive computational results across a variety of networks are reported. These results indicate that the presented solution procedure outperforms the other methods in the literature and is effective for a wide range of traffic loads.
基金supported by the National Natural Science Foundation of China(Grant No.11075210)the Postdoctoral Science Foundation of China(GrantNo.201104761)
文摘A virtual cathode oscillator （VCO） with a resonant cavity is presented and investigated numerically and theoretically, and its efficiency and stability are enhanced. An equivalent circuit method is introduced to analyze the resonant cavity com- posed of anode foil and feedback annulus, and a theoretical expression for the fundamental mode frequency of the resonant cavity is given. The VCO is investigated in detail with a particle-in-cell method. We obtain the microwave frequencies from simulation, theoretical expression, and relative references, and draw three important conclusions. First, the microwave fre- quency is a constant when the diode voltage is changed from 588 kV to 717 kV. Second, the fluctuation of the microwave frequency is very small when the AK gap is changed from 1.2 cm to 1.6 cm. Third, the microwave frequency agrees with the theoretical result. The relative error, which is calculated according to the theoretical and simulation frequencies, is only 1.7%.
文摘单相开路故障的五相永磁同步电机(permanent-magnet synchronous motor,PMSM)采用有限集模型预测转矩和磁链控制(finite-control-set model predictive torque and flux control,FCS-MPTFC)策略,存在转矩脉动大、价值函数的权重系数整定困难、迭代计算量大以及共模电压(commonmode voltage,CMV)高等问题。为此,该文提出一种简化FCS-MPTFC策略。首先,建立五相PMSM在单相开路故障情况下的数学模型,并分析CMV产生的机理。其次,以抑制3次谐波电流的原则合成等幅值虚拟电压矢量(virtual voltage vector,V^(3)),并将转矩和磁链价值函数等效转化为电压价值函数,同时采用无差拍控制思想计算出参考电压矢量,进而通过合理划分扇区,直接获得最优V^(3)。最后,选择方向相反的两个基电压矢量代替零矢量,以减小开路故障下的CMV。仿真和实验结果表明:所提控制策略不仅能抑制单相开路故障导致的转矩脉动、降低计算负荷和CMV、抑制电流谐波,而且具有优良的稳态和动态性能。
