A Ru-La/ZrO2 catalyst was prepared by the precipitation method, in which Ru was an active component, La was a promoter and ZrO2 was a dispersant. Comparing with the catalyst prepared by the chemical reduction method, ...A Ru-La/ZrO2 catalyst was prepared by the precipitation method, in which Ru was an active component, La was a promoter and ZrO2 was a dispersant. Comparing with the catalyst prepared by the chemical reduction method, the Ru-La/ZrO2 exhibited higher activity and better selectivity. At 140 ℃ and hydrogen pressure of 5 MPa, the C6H10 selectivity reached 70% at a C6H6 conversion of 35% for a reaction time was 5 min and the total La/Ru loading was 10%. Textural parameters of the catalyst were obtained by physical adsorption, BET surface area and specific pore volume measurements. The catalyst sample gave a BET area of 41 m2/g and a specific pore volume of 1.1 cm^3/g, and the most probable pore distribution was located at 5 to 10 nm. H2-TPR measurements showed that ruthenium oxide could be reduced to its metallic state at about 403 K. XRD determinations indicated that ruthenium and lanthanum were highly dispersed on the zirconia. A significant advantage of the Ru-La/ZrO2 catalyst is that it can be used directly in its unreduced state for the selective hydrogenation of benzene.展开更多
SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long lifespan.However,the intrinsically high thermal conductivity of Si-based m...SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long lifespan.However,the intrinsically high thermal conductivity of Si-based materials also results in poor TE properties.In this investigation,a zirconia(ZrO_(2))composite strategy was applied to an n-type SiGe alloy,tremendously elevating its TE performance.After mechanical alloying and spark plasma sintering(SPS)processes,the ZrO_(2)induced the formation of nanopores in the SiGe matrix via phosphorus adsorption.Moreover,such increase in porosity enhanced the phonon scattering and dramatically suppressed lattice thermal conductivity,from 2.83 to 1.59 W·m^(-1)·K^(-1)at 873 K.Additionally,reduced phosphorus doping led to an increase in Seebeck coefficients and a relatively minor decrease in electrical conductivity,The power factor didn't deteriorate significantly,either,as its maximum of~3.43 mW·m^(-1-)K^(-2)was achieved at 873 K with(Si_(0.8)Ge_(0.2))_(0.097)P_(0.03)(ZrO_(2))_(0.003).In short,a peak figure of merit(ZT)of~1.27 at 873 K and an average ZT~0.7 from 323 to 873 K were obtained.This study demonstrates that the electrical and thermal transportation of SiGe material can be synergistically tuned by compositing ZrO_(2),illustrating a novel strategy to optimize the TE properties of bulk materials.展开更多
A S 2O 2- 8/ZrO 2 Al 2O 3 type solid superacid catalyst was prepared from ZrOCl 2·8H 2O, AlCl 3· 6H 2O and (NH 4) 2S 2O 8 by coprecipitation, maceration and calcination processes. Their crystal structures an...A S 2O 2- 8/ZrO 2 Al 2O 3 type solid superacid catalyst was prepared from ZrOCl 2·8H 2O, AlCl 3· 6H 2O and (NH 4) 2S 2O 8 by coprecipitation, maceration and calcination processes. Their crystal structures and acidities were determined by XRD and Hammett method, respectively. The activity of the catalyst was studied as function of Al 2O 3 content, calcination temperature and time in the esterification of acetic acid with butanol, and a conversion of 96 5% was obtained. The catalyst gave also higher yields in syntheses of ketals and acetals: cyclohexanone ethylene ketal(86 2%), acetophenone ethylene ketal(78 5%), acetylacetic ester ketal(88 5%), benzaldehyde glycol acetal(76 3%). The chemical structures of the products were confirmed by IR spectra.展开更多
以纳米ZrO 、微米Al O 为原料,采用无压烧结方式制备了ZTA 复相陶瓷。结果表明:nano-ZrO 的 2 2 3 2加入有利于制备细晶ZTA 复相陶瓷。此外,nano-ZrO 的加入对 Al O 陶瓷的显微结构也产生影响,ZrO ...以纳米ZrO 、微米Al O 为原料,采用无压烧结方式制备了ZTA 复相陶瓷。结果表明:nano-ZrO 的 2 2 3 2加入有利于制备细晶ZTA 复相陶瓷。此外,nano-ZrO 的加入对 Al O 陶瓷的显微结构也产生影响,ZrO 颗粒以 2 2 3 2“晶内型”和晶界型两种形式存在。合理的配方组成及制备工艺有利于 Z r O 以四方亚稳相存在。Z r O 含量为 2 23 0 w t % 时,其四方相含量可达 6 9 %,有利于应力诱导相变增韧,该 Z T A 复相陶瓷的抗弯强度、断裂韧性分别达到 604MPa、6.87MPa·m1/2。展开更多
文摘A Ru-La/ZrO2 catalyst was prepared by the precipitation method, in which Ru was an active component, La was a promoter and ZrO2 was a dispersant. Comparing with the catalyst prepared by the chemical reduction method, the Ru-La/ZrO2 exhibited higher activity and better selectivity. At 140 ℃ and hydrogen pressure of 5 MPa, the C6H10 selectivity reached 70% at a C6H6 conversion of 35% for a reaction time was 5 min and the total La/Ru loading was 10%. Textural parameters of the catalyst were obtained by physical adsorption, BET surface area and specific pore volume measurements. The catalyst sample gave a BET area of 41 m2/g and a specific pore volume of 1.1 cm^3/g, and the most probable pore distribution was located at 5 to 10 nm. H2-TPR measurements showed that ruthenium oxide could be reduced to its metallic state at about 403 K. XRD determinations indicated that ruthenium and lanthanum were highly dispersed on the zirconia. A significant advantage of the Ru-La/ZrO2 catalyst is that it can be used directly in its unreduced state for the selective hydrogenation of benzene.
基金financially supported by the National Key Research and Development Program of China(Nos.2022YFE0119100 and 2017YFE0198000)the National Natural Science Foundation of China(Nos.U21A2054,52273285,52061009 and 52262032)Guangxi Science and Technology Planning Project(No.AD21220056)。
文摘SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long lifespan.However,the intrinsically high thermal conductivity of Si-based materials also results in poor TE properties.In this investigation,a zirconia(ZrO_(2))composite strategy was applied to an n-type SiGe alloy,tremendously elevating its TE performance.After mechanical alloying and spark plasma sintering(SPS)processes,the ZrO_(2)induced the formation of nanopores in the SiGe matrix via phosphorus adsorption.Moreover,such increase in porosity enhanced the phonon scattering and dramatically suppressed lattice thermal conductivity,from 2.83 to 1.59 W·m^(-1)·K^(-1)at 873 K.Additionally,reduced phosphorus doping led to an increase in Seebeck coefficients and a relatively minor decrease in electrical conductivity,The power factor didn't deteriorate significantly,either,as its maximum of~3.43 mW·m^(-1-)K^(-2)was achieved at 873 K with(Si_(0.8)Ge_(0.2))_(0.097)P_(0.03)(ZrO_(2))_(0.003).In short,a peak figure of merit(ZT)of~1.27 at 873 K and an average ZT~0.7 from 323 to 873 K were obtained.This study demonstrates that the electrical and thermal transportation of SiGe material can be synergistically tuned by compositing ZrO_(2),illustrating a novel strategy to optimize the TE properties of bulk materials.
文摘A S 2O 2- 8/ZrO 2 Al 2O 3 type solid superacid catalyst was prepared from ZrOCl 2·8H 2O, AlCl 3· 6H 2O and (NH 4) 2S 2O 8 by coprecipitation, maceration and calcination processes. Their crystal structures and acidities were determined by XRD and Hammett method, respectively. The activity of the catalyst was studied as function of Al 2O 3 content, calcination temperature and time in the esterification of acetic acid with butanol, and a conversion of 96 5% was obtained. The catalyst gave also higher yields in syntheses of ketals and acetals: cyclohexanone ethylene ketal(86 2%), acetophenone ethylene ketal(78 5%), acetylacetic ester ketal(88 5%), benzaldehyde glycol acetal(76 3%). The chemical structures of the products were confirmed by IR spectra.
文摘以纳米ZrO 、微米Al O 为原料,采用无压烧结方式制备了ZTA 复相陶瓷。结果表明:nano-ZrO 的 2 2 3 2加入有利于制备细晶ZTA 复相陶瓷。此外,nano-ZrO 的加入对 Al O 陶瓷的显微结构也产生影响,ZrO 颗粒以 2 2 3 2“晶内型”和晶界型两种形式存在。合理的配方组成及制备工艺有利于 Z r O 以四方亚稳相存在。Z r O 含量为 2 23 0 w t % 时,其四方相含量可达 6 9 %,有利于应力诱导相变增韧,该 Z T A 复相陶瓷的抗弯强度、断裂韧性分别达到 604MPa、6.87MPa·m1/2。
