To increase the strength of the laser powder-bed fusion (LPBF) Al-Si-based aluminum alloy, TiB_(2) ceramic particles were selected to be mixed with high-Mg content Al-Si-Mg-Zr powder, and then a novel TiB_(2)/Al-Si-Mg...To increase the strength of the laser powder-bed fusion (LPBF) Al-Si-based aluminum alloy, TiB_(2) ceramic particles were selected to be mixed with high-Mg content Al-Si-Mg-Zr powder, and then a novel TiB_(2)/Al-Si-Mg-Zr composite was fabricated using LPBF. The results indicated that a dense sample with a maximum relative density of 99.85% could be obtained by adjusting the LPBF process parameters. Incorporating TiB_(2) nanoparticles enhanced the powder's laser absorption rate, thereby raising the alloy's intrinsic heat treatment temperature and consequently facilitating the precipitation of Si and βʺ nanoparticles in the α-Al cells. Moreover, the rapid cooling process during LPBF resulted in numerous alloying elements with low-stacking fault energy dissolving in the α-Al matrix, thus promoting the formation of the 9R phase. After a 48 h direct aging treatment at 150℃, the strength of the alloy slightly increased due to the increase of nanoprecipitates. Both yield strength and ultimate tensile strength of the LPBF TiB_(2)/Al-Si-Mg-Zr alloy were significantly higher than that of other LPBF TiB_(2)-modified aluminum alloys with external addition.展开更多
基金supported by the National Natural Science Foundation of China(Nos.51801079 and 52001140)the National Science Centre,Poland(Narodowe Centrum Nauki)(No.UMO-2021/42/E/ST5/00339).
文摘To increase the strength of the laser powder-bed fusion (LPBF) Al-Si-based aluminum alloy, TiB_(2) ceramic particles were selected to be mixed with high-Mg content Al-Si-Mg-Zr powder, and then a novel TiB_(2)/Al-Si-Mg-Zr composite was fabricated using LPBF. The results indicated that a dense sample with a maximum relative density of 99.85% could be obtained by adjusting the LPBF process parameters. Incorporating TiB_(2) nanoparticles enhanced the powder's laser absorption rate, thereby raising the alloy's intrinsic heat treatment temperature and consequently facilitating the precipitation of Si and βʺ nanoparticles in the α-Al cells. Moreover, the rapid cooling process during LPBF resulted in numerous alloying elements with low-stacking fault energy dissolving in the α-Al matrix, thus promoting the formation of the 9R phase. After a 48 h direct aging treatment at 150℃, the strength of the alloy slightly increased due to the increase of nanoprecipitates. Both yield strength and ultimate tensile strength of the LPBF TiB_(2)/Al-Si-Mg-Zr alloy were significantly higher than that of other LPBF TiB_(2)-modified aluminum alloys with external addition.
