基于TSMC 0.13μm CMOS工艺设计了一款适用于无线传感网络、工作频率为300~400 MHz的两级功率放大器。功率放大器驱动级采用共源共栅结构,输出级采用了3-stack FET结构,采用线性化技术改进传统偏置电路,提高了功率放大器线性度。电源电...基于TSMC 0.13μm CMOS工艺设计了一款适用于无线传感网络、工作频率为300~400 MHz的两级功率放大器。功率放大器驱动级采用共源共栅结构,输出级采用了3-stack FET结构,采用线性化技术改进传统偏置电路,提高了功率放大器线性度。电源电压为3.6 V,芯片面积为0.31 mm×0.35 mm。利用Cadence Spectre RF软件工具对所设计的功率放大器电路进行仿真,结果表明,工作频率为350 MHz时,功率放大器的饱和输出功率为24.2 d Bm,最大功率附加效率为52.5%,小信号增益达到38.15 d B。在300~400 MHz频带内功率放大器的饱和输出功率大于23.9 d Bm,1 d B压缩点输出功率大于22.9 d Bm,最大功率附加效率大于47%,小信号增益大于37 d B,增益平坦度小于±0.7 d B。展开更多
A novel double-foot piezoelectric linear motor is proposed.The kinematic model of the motor under stepping motion is presented.The motor mainly consists of a stator with four piezoelectric stacks,a mover,a holding mec...A novel double-foot piezoelectric linear motor is proposed.The kinematic model of the motor under stepping motion is presented.The motor mainly consists of a stator with four piezoelectric stacks,a mover,a holding mechanism,and a preloading mechanism to achieve large stroke with high resolution.Finite element simulations are carried out to analyze the motion characteristics of the motor.A prototype is fabricated and a serial experiments are conducted to validate the feasibility of the motor principle.Experimental results indicate that the motor can move at a speed of 670.22μm/s with a driving frequency of 120 Hz and a voltage of 120 V.The resolution of the proposed motor is 3.6μm while the resolution of the single-step motion is 0.1μm.展开更多
The existing resonant linear piezoelectric motors must operate with high working voltage in resonant condition,resulting in their narrow operating frequency range and poor running stability.Here,with the large displac...The existing resonant linear piezoelectric motors must operate with high working voltage in resonant condition,resulting in their narrow operating frequency range and poor running stability.Here,with the large displacement output characteristics of piezoelectric stacks,the trajectory at the drive foot of stator is firstly produced with two space quadrature piezoelectric actuators excited by sawtooth wave and square wave.Secondly,the friction drive principle of motor is used to analyze the working mechanisms of the continuous stepping motion.Finally,the motor prototype is designed and experiments are carried out.The experimental result shows that the motor can stably operate within the scope of 350 Hz to 750 Hz.When the excitation voltage is 30 Vand pre-load is 3Nor10 N,the lateral amplitude of the drive foot is approximately 4μm and the stable average interval ranges from3.1μm to 3.2μm with the error rate of 5%—7.5%.展开更多
文摘基于TSMC 0.13μm CMOS工艺设计了一款适用于无线传感网络、工作频率为300~400 MHz的两级功率放大器。功率放大器驱动级采用共源共栅结构,输出级采用了3-stack FET结构,采用线性化技术改进传统偏置电路,提高了功率放大器线性度。电源电压为3.6 V,芯片面积为0.31 mm×0.35 mm。利用Cadence Spectre RF软件工具对所设计的功率放大器电路进行仿真,结果表明,工作频率为350 MHz时,功率放大器的饱和输出功率为24.2 d Bm,最大功率附加效率为52.5%,小信号增益达到38.15 d B。在300~400 MHz频带内功率放大器的饱和输出功率大于23.9 d Bm,1 d B压缩点输出功率大于22.9 d Bm,最大功率附加效率大于47%,小信号增益大于37 d B,增益平坦度小于±0.7 d B。
基金supported by the National Natural Science Foundations of China (Nos.51505161,51375224)the Guangzhou Municipal University Research Projects (No.1201610315)
文摘A novel double-foot piezoelectric linear motor is proposed.The kinematic model of the motor under stepping motion is presented.The motor mainly consists of a stator with four piezoelectric stacks,a mover,a holding mechanism,and a preloading mechanism to achieve large stroke with high resolution.Finite element simulations are carried out to analyze the motion characteristics of the motor.A prototype is fabricated and a serial experiments are conducted to validate the feasibility of the motor principle.Experimental results indicate that the motor can move at a speed of 670.22μm/s with a driving frequency of 120 Hz and a voltage of 120 V.The resolution of the proposed motor is 3.6μm while the resolution of the single-step motion is 0.1μm.
基金supported by the National Natural Science Foundation of China (Nos.51375224,51405420)the Natural Science Foundation of Jiangsu Province (No.BK20140474)
文摘The existing resonant linear piezoelectric motors must operate with high working voltage in resonant condition,resulting in their narrow operating frequency range and poor running stability.Here,with the large displacement output characteristics of piezoelectric stacks,the trajectory at the drive foot of stator is firstly produced with two space quadrature piezoelectric actuators excited by sawtooth wave and square wave.Secondly,the friction drive principle of motor is used to analyze the working mechanisms of the continuous stepping motion.Finally,the motor prototype is designed and experiments are carried out.The experimental result shows that the motor can stably operate within the scope of 350 Hz to 750 Hz.When the excitation voltage is 30 Vand pre-load is 3Nor10 N,the lateral amplitude of the drive foot is approximately 4μm and the stable average interval ranges from3.1μm to 3.2μm with the error rate of 5%—7.5%.
