A compliant F/T sensor which combines passive compliance and active sensing is proposed in thes paper to provide flexible utility. The paper describes the sensor’s mechanical design, measuring theory and kinematic eq...A compliant F/T sensor which combines passive compliance and active sensing is proposed in thes paper to provide flexible utility. The paper describes the sensor’s mechanical design, measuring theory and kinematic equations which are set up in the RPY (roll-pitch-yaw) mode.The sensor’S poSe vector can be acquired if the position signals from the PSDS are known, and vice versa. The formula between force vector and pose vector is built so that the force/ torque can be acquired after the stiffness matrix is calibrated.展开更多
This paper presents a proposed low-noise and high-sensitivity Internet of Thing(IoT)system based on an M&NEMS microphone.The IoT device consists of an M&NEMS resistive accelerometer associated with an electron...This paper presents a proposed low-noise and high-sensitivity Internet of Thing(IoT)system based on an M&NEMS microphone.The IoT device consists of an M&NEMS resistive accelerometer associated with an electronic readout circuit,which is a silicon nanowire and a Continuous-Time(CT)△∑ADC.The first integrator of the△∑ADC is based on a positive feedback DC-gain enhancement two-stage amplifier due to its high linearity and low-noise operations.To mitigate both the offset and 1/f noise,a suggested delay-time chopper negative-R stabilization technique is applied around the first integrator.A 65-nm CMOS process implements the CT△∑ADC.The supply voltage of the CMOS circuit is 1.2-V while 0.96-mW is the power consumption and 0.1-mm^(2) is the silicon area.The M&NEMS microphone and△∑ADC complete circuit are fabricated and measured.Over a working frequency bandwidth of 20-kHz,the measurement results of the proposed IoT system reach a signal to noise ratio(SNR)of 102.8-dB.Moreover,it has a measured dynamic range(DR)of 108-dB and a measured signal to noise and distortion ratio(SNDR)of 101.3-dB.展开更多
The security of civil engineering is an important task due to the economic, social and environmental significance. Compared with conventional sensors, the optical fiber sensors have their unique characteristics.Being ...The security of civil engineering is an important task due to the economic, social and environmental significance. Compared with conventional sensors, the optical fiber sensors have their unique characteristics.Being durable, stable and insensitive to external perturbations,they are particular interesting for the long-term monitoring of civil structures.Focus is on absolute measurement optical fiber sensors, which are emerging from the monitoring large structural, including SOFO system, F-P optical fiber sensors, and fiber Bragg grating sensors. The principle, characteristic and application of these three kinds of optical fiber sensors are described together with their future prospects.展开更多
A kind of wireless sensor was previously developed,which is powered and transmit signals wirelessly instead of using an electrical connection to the embedded reinforcement.Based on this technique,the relationship betw...A kind of wireless sensor was previously developed,which is powered and transmit signals wirelessly instead of using an electrical connection to the embedded reinforcement.Based on this technique,the relationship between diameters of corroded sensing steel wires and corrosion levels of steel bars is established by experiments.Quadratic function is utilized to fit the experiment results,and the correlation coefficients are all larger than 0.95.Estimated corrosion levels of commonly used steel bars are given for different diameters of corroded sensing steel wires fractured due to corrosion.展开更多
An integrated front-end vertical CMOS Hall magnetic sensor is proposed for the in-plane magnetic field measure-ment.To improve the magnetic sensitivity and to obtain low offset,a fully symmetric vertical Hall device(F...An integrated front-end vertical CMOS Hall magnetic sensor is proposed for the in-plane magnetic field measure-ment.To improve the magnetic sensitivity and to obtain low offset,a fully symmetric vertical Hall device(FSVHD)has been op-timized with a minimum size design.A new four-phase spinning current modulation associated with a correlated double sampling(CDS)demodulation technique has been further applied to compensate for the offset and also to provide a linear Hall output voltage.The vertical Hall sensor chip has been manufactured in a 0.18μm low-voltage CMOS technology and it occu-pies an area of 1.54 mm2.The experimental results show in the magnetic field range from-200 to 200 mT,the entire vertical Hall sensor performs with the linearity of 99.9%and the system magnetic sensitivity of 1.22 V/T and the residual offset of 60μT.Meanwhile,it consumes 4.5 mW at a 3.3 V supply voltage.The proposed vertical Hall sensor is very suitable for the low-cost sys-tem-on-chip(SOC)implementation of 2D or 3D magnetic microsystems.展开更多
In order to overcome the deficiencies of traditional pressure sensors, a kind of intelligent pressure sensors with temperature correction is designed. Qccording to the intelligent sensor system of composition and rang...In order to overcome the deficiencies of traditional pressure sensors, a kind of intelligent pressure sensors with temperature correction is designed. Qccording to the intelligent sensor system of composition and range of applications, with fully taking into account the parameters of the connection between of co-ordination, we chose a good usability, high reliability and low cost components composed of the entire measurement system, with controlling and dealing with in 80C51 miller, the system had the temperature and pressure parameters with automatic measurement, amplification, A/D conversion, the weak signal locked amplification, as well as PhaseSensitive Detection （PSD）, common-mode signal rejection, the collected signal de-noising processing, cross-sensitivity of the decoupling and show the results. It also has a self-test, automatic temperature condition and on, site communications and other functions.展开更多
In this paper, the reflective spectra of a refraction index sensor were analyzed based on fiber grating F-P cavity. The sensor was constituted by two identical fiber gratings. Compared with the refraction index sensor...In this paper, the reflective spectra of a refraction index sensor were analyzed based on fiber grating F-P cavity. The sensor was constituted by two identical fiber gratings. Compared with the refraction index sensor using one fiber grating, the fiber grating F-P cavity sensor has narrower resonant peak and it can be used for more accurate measurement. The resonant peaks in the reflective spectra of the sensor are changed with small changes of the refraction index of the measured chemical liquids or cell samples. So it has potential applications in biology and chemistry.展开更多
变压器能否稳定工作直接关系到变电站是否安全运行,其工作重心是检测出变压器局部放电产生的超声波信号。介绍了一种光纤F-P腔传感器,并在此基础上搭建了调制解调系统,分别通过对无超声波源、有超声波源和浸入变压器油中3种情况进行了...变压器能否稳定工作直接关系到变电站是否安全运行,其工作重心是检测出变压器局部放电产生的超声波信号。介绍了一种光纤F-P腔传感器,并在此基础上搭建了调制解调系统,分别通过对无超声波源、有超声波源和浸入变压器油中3种情况进行了实验测试,并在距离超声波源20,40,60,80,90,100 cm处进行了损耗特性测试,测试结果表明:此传感器受外界噪声干扰较小,且在变压器油中能实时地检测出超声波信号,精度高,损耗度为25.8 m V/cm,符合传感器在油浸式变压器中持续稳定工作的条件。当变压器出现故障时,能够及时发现问题,保证变压器安全运行。展开更多
文摘A compliant F/T sensor which combines passive compliance and active sensing is proposed in thes paper to provide flexible utility. The paper describes the sensor’s mechanical design, measuring theory and kinematic equations which are set up in the RPY (roll-pitch-yaw) mode.The sensor’S poSe vector can be acquired if the position signals from the PSDS are known, and vice versa. The formula between force vector and pose vector is built so that the force/ torque can be acquired after the stiffness matrix is calibrated.
文摘This paper presents a proposed low-noise and high-sensitivity Internet of Thing(IoT)system based on an M&NEMS microphone.The IoT device consists of an M&NEMS resistive accelerometer associated with an electronic readout circuit,which is a silicon nanowire and a Continuous-Time(CT)△∑ADC.The first integrator of the△∑ADC is based on a positive feedback DC-gain enhancement two-stage amplifier due to its high linearity and low-noise operations.To mitigate both the offset and 1/f noise,a suggested delay-time chopper negative-R stabilization technique is applied around the first integrator.A 65-nm CMOS process implements the CT△∑ADC.The supply voltage of the CMOS circuit is 1.2-V while 0.96-mW is the power consumption and 0.1-mm^(2) is the silicon area.The M&NEMS microphone and△∑ADC complete circuit are fabricated and measured.Over a working frequency bandwidth of 20-kHz,the measurement results of the proposed IoT system reach a signal to noise ratio(SNR)of 102.8-dB.Moreover,it has a measured dynamic range(DR)of 108-dB and a measured signal to noise and distortion ratio(SNDR)of 101.3-dB.
文摘The security of civil engineering is an important task due to the economic, social and environmental significance. Compared with conventional sensors, the optical fiber sensors have their unique characteristics.Being durable, stable and insensitive to external perturbations,they are particular interesting for the long-term monitoring of civil structures.Focus is on absolute measurement optical fiber sensors, which are emerging from the monitoring large structural, including SOFO system, F-P optical fiber sensors, and fiber Bragg grating sensors. The principle, characteristic and application of these three kinds of optical fiber sensors are described together with their future prospects.
基金supported by the National Natural Science Foundation of China(No.51279074)
文摘A kind of wireless sensor was previously developed,which is powered and transmit signals wirelessly instead of using an electrical connection to the embedded reinforcement.Based on this technique,the relationship between diameters of corroded sensing steel wires and corrosion levels of steel bars is established by experiments.Quadratic function is utilized to fit the experiment results,and the correlation coefficients are all larger than 0.95.Estimated corrosion levels of commonly used steel bars are given for different diameters of corroded sensing steel wires fractured due to corrosion.
基金the National Natural Science Foundation of China(Nos.61871231,62171233)the Natural Science Foundation of Jiangsu Province,China(No.BK20181390)+1 种基金the Key Research&Development Plan of Jiangsu Province,China(No.BE2019741)the Agricultural Science and Technology Independent Innovation Foundation of Jiangsu Province,China(No.CX(21)3062).
文摘An integrated front-end vertical CMOS Hall magnetic sensor is proposed for the in-plane magnetic field measure-ment.To improve the magnetic sensitivity and to obtain low offset,a fully symmetric vertical Hall device(FSVHD)has been op-timized with a minimum size design.A new four-phase spinning current modulation associated with a correlated double sampling(CDS)demodulation technique has been further applied to compensate for the offset and also to provide a linear Hall output voltage.The vertical Hall sensor chip has been manufactured in a 0.18μm low-voltage CMOS technology and it occu-pies an area of 1.54 mm2.The experimental results show in the magnetic field range from-200 to 200 mT,the entire vertical Hall sensor performs with the linearity of 99.9%and the system magnetic sensitivity of 1.22 V/T and the residual offset of 60μT.Meanwhile,it consumes 4.5 mW at a 3.3 V supply voltage.The proposed vertical Hall sensor is very suitable for the low-cost sys-tem-on-chip(SOC)implementation of 2D or 3D magnetic microsystems.
文摘In order to overcome the deficiencies of traditional pressure sensors, a kind of intelligent pressure sensors with temperature correction is designed. Qccording to the intelligent sensor system of composition and range of applications, with fully taking into account the parameters of the connection between of co-ordination, we chose a good usability, high reliability and low cost components composed of the entire measurement system, with controlling and dealing with in 80C51 miller, the system had the temperature and pressure parameters with automatic measurement, amplification, A/D conversion, the weak signal locked amplification, as well as PhaseSensitive Detection （PSD）, common-mode signal rejection, the collected signal de-noising processing, cross-sensitivity of the decoupling and show the results. It also has a self-test, automatic temperature condition and on, site communications and other functions.
基金National Natural Science Foundation of China(10774058)
文摘In this paper, the reflective spectra of a refraction index sensor were analyzed based on fiber grating F-P cavity. The sensor was constituted by two identical fiber gratings. Compared with the refraction index sensor using one fiber grating, the fiber grating F-P cavity sensor has narrower resonant peak and it can be used for more accurate measurement. The resonant peaks in the reflective spectra of the sensor are changed with small changes of the refraction index of the measured chemical liquids or cell samples. So it has potential applications in biology and chemistry.
文摘变压器能否稳定工作直接关系到变电站是否安全运行,其工作重心是检测出变压器局部放电产生的超声波信号。介绍了一种光纤F-P腔传感器,并在此基础上搭建了调制解调系统,分别通过对无超声波源、有超声波源和浸入变压器油中3种情况进行了实验测试,并在距离超声波源20,40,60,80,90,100 cm处进行了损耗特性测试,测试结果表明:此传感器受外界噪声干扰较小,且在变压器油中能实时地检测出超声波信号,精度高,损耗度为25.8 m V/cm,符合传感器在油浸式变压器中持续稳定工作的条件。当变压器出现故障时,能够及时发现问题,保证变压器安全运行。
