SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long lifespan.However,the intrinsically high thermal conductivity of Si-based m...SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long lifespan.However,the intrinsically high thermal conductivity of Si-based materials also results in poor TE properties.In this investigation,a zirconia(ZrO_(2))composite strategy was applied to an n-type SiGe alloy,tremendously elevating its TE performance.After mechanical alloying and spark plasma sintering(SPS)processes,the ZrO_(2)induced the formation of nanopores in the SiGe matrix via phosphorus adsorption.Moreover,such increase in porosity enhanced the phonon scattering and dramatically suppressed lattice thermal conductivity,from 2.83 to 1.59 W·m^(-1)·K^(-1)at 873 K.Additionally,reduced phosphorus doping led to an increase in Seebeck coefficients and a relatively minor decrease in electrical conductivity,The power factor didn't deteriorate significantly,either,as its maximum of~3.43 mW·m^(-1-)K^(-2)was achieved at 873 K with(Si_(0.8)Ge_(0.2))_(0.097)P_(0.03)(ZrO_(2))_(0.003).In short,a peak figure of merit(ZT)of~1.27 at 873 K and an average ZT~0.7 from 323 to 873 K were obtained.This study demonstrates that the electrical and thermal transportation of SiGe material can be synergistically tuned by compositing ZrO_(2),illustrating a novel strategy to optimize the TE properties of bulk materials.展开更多
Hollow CuO-CeO2-ZrO2nano-particles were prepared with supercritical anti-solvent apparatus by using methanol as sol-vent and supercritical carbon dioxide as anti-solvent. Two key factors （i.e., pressure and temperat...Hollow CuO-CeO2-ZrO2nano-particles were prepared with supercritical anti-solvent apparatus by using methanol as sol-vent and supercritical carbon dioxide as anti-solvent. Two key factors （i.e., pressure and temperature） were investigated to explore the effects of catalyst structure and physic-chemical properties （i.e., morphology, reducing property, oxygen storage capacity and specific surface area）. The resulting materials were characterized with X-ray diffraction （XRD）, high resolution transmission electron micros-copy （HRTEM）, Brunauer-Emmett-Teller （BET）,hydrogen temperature programmed reduction （H2-TPR） and oxygen storage capac-ity （OSC） measurement, respectively. The experimental results showed that lower temperatures promoted production of hollow struc-ture nano-particulates. The particle morphology also changed significantly, i.e. the solid construction was first transferred to hollow structure then back to solid construction. The optimal conditions for obtaining hollow nano-particles were determined at 45 °C, 18.0–24.0 MPa.展开更多
A S 2O 2- 8/ZrO 2 Al 2O 3 type solid superacid catalyst was prepared from ZrOCl 2·8H 2O, AlCl 3· 6H 2O and (NH 4) 2S 2O 8 by coprecipitation, maceration and calcination processes. Their crystal structures an...A S 2O 2- 8/ZrO 2 Al 2O 3 type solid superacid catalyst was prepared from ZrOCl 2·8H 2O, AlCl 3· 6H 2O and (NH 4) 2S 2O 8 by coprecipitation, maceration and calcination processes. Their crystal structures and acidities were determined by XRD and Hammett method, respectively. The activity of the catalyst was studied as function of Al 2O 3 content, calcination temperature and time in the esterification of acetic acid with butanol, and a conversion of 96 5% was obtained. The catalyst gave also higher yields in syntheses of ketals and acetals: cyclohexanone ethylene ketal(86 2%), acetophenone ethylene ketal(78 5%), acetylacetic ester ketal(88 5%), benzaldehyde glycol acetal(76 3%). The chemical structures of the products were confirmed by IR spectra.展开更多
以纳米ZrO 、微米Al O 为原料,采用无压烧结方式制备了ZTA 复相陶瓷。结果表明:nano-ZrO 的 2 2 3 2加入有利于制备细晶ZTA 复相陶瓷。此外,nano-ZrO 的加入对 Al O 陶瓷的显微结构也产生影响,ZrO ...以纳米ZrO 、微米Al O 为原料,采用无压烧结方式制备了ZTA 复相陶瓷。结果表明:nano-ZrO 的 2 2 3 2加入有利于制备细晶ZTA 复相陶瓷。此外,nano-ZrO 的加入对 Al O 陶瓷的显微结构也产生影响,ZrO 颗粒以 2 2 3 2“晶内型”和晶界型两种形式存在。合理的配方组成及制备工艺有利于 Z r O 以四方亚稳相存在。Z r O 含量为 2 23 0 w t % 时,其四方相含量可达 6 9 %,有利于应力诱导相变增韧,该 Z T A 复相陶瓷的抗弯强度、断裂韧性分别达到 604MPa、6.87MPa·m1/2。展开更多
基金financially supported by the National Key Research and Development Program of China(Nos.2022YFE0119100 and 2017YFE0198000)the National Natural Science Foundation of China(Nos.U21A2054,52273285,52061009 and 52262032)Guangxi Science and Technology Planning Project(No.AD21220056)。
文摘SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long lifespan.However,the intrinsically high thermal conductivity of Si-based materials also results in poor TE properties.In this investigation,a zirconia(ZrO_(2))composite strategy was applied to an n-type SiGe alloy,tremendously elevating its TE performance.After mechanical alloying and spark plasma sintering(SPS)processes,the ZrO_(2)induced the formation of nanopores in the SiGe matrix via phosphorus adsorption.Moreover,such increase in porosity enhanced the phonon scattering and dramatically suppressed lattice thermal conductivity,from 2.83 to 1.59 W·m^(-1)·K^(-1)at 873 K.Additionally,reduced phosphorus doping led to an increase in Seebeck coefficients and a relatively minor decrease in electrical conductivity,The power factor didn't deteriorate significantly,either,as its maximum of~3.43 mW·m^(-1-)K^(-2)was achieved at 873 K with(Si_(0.8)Ge_(0.2))_(0.097)P_(0.03)(ZrO_(2))_(0.003).In short,a peak figure of merit(ZT)of~1.27 at 873 K and an average ZT~0.7 from 323 to 873 K were obtained.This study demonstrates that the electrical and thermal transportation of SiGe material can be synergistically tuned by compositing ZrO_(2),illustrating a novel strategy to optimize the TE properties of bulk materials.
基金supported by the National Natural Science Foundation of China(20976120)Natural Science Foundation of Tianjin(09JCYBJC06200)
文摘Hollow CuO-CeO2-ZrO2nano-particles were prepared with supercritical anti-solvent apparatus by using methanol as sol-vent and supercritical carbon dioxide as anti-solvent. Two key factors （i.e., pressure and temperature） were investigated to explore the effects of catalyst structure and physic-chemical properties （i.e., morphology, reducing property, oxygen storage capacity and specific surface area）. The resulting materials were characterized with X-ray diffraction （XRD）, high resolution transmission electron micros-copy （HRTEM）, Brunauer-Emmett-Teller （BET）,hydrogen temperature programmed reduction （H2-TPR） and oxygen storage capac-ity （OSC） measurement, respectively. The experimental results showed that lower temperatures promoted production of hollow struc-ture nano-particulates. The particle morphology also changed significantly, i.e. the solid construction was first transferred to hollow structure then back to solid construction. The optimal conditions for obtaining hollow nano-particles were determined at 45 °C, 18.0–24.0 MPa.
基金National Natural Science Foundation of China(21076206)Natural Basic Research Program of China(973 Program,2010CB732302)National High Technology Research and Development Program(863 Program,2011AA050706)
文摘A S 2O 2- 8/ZrO 2 Al 2O 3 type solid superacid catalyst was prepared from ZrOCl 2·8H 2O, AlCl 3· 6H 2O and (NH 4) 2S 2O 8 by coprecipitation, maceration and calcination processes. Their crystal structures and acidities were determined by XRD and Hammett method, respectively. The activity of the catalyst was studied as function of Al 2O 3 content, calcination temperature and time in the esterification of acetic acid with butanol, and a conversion of 96 5% was obtained. The catalyst gave also higher yields in syntheses of ketals and acetals: cyclohexanone ethylene ketal(86 2%), acetophenone ethylene ketal(78 5%), acetylacetic ester ketal(88 5%), benzaldehyde glycol acetal(76 3%). The chemical structures of the products were confirmed by IR spectra.
文摘以纳米ZrO 、微米Al O 为原料,采用无压烧结方式制备了ZTA 复相陶瓷。结果表明:nano-ZrO 的 2 2 3 2加入有利于制备细晶ZTA 复相陶瓷。此外,nano-ZrO 的加入对 Al O 陶瓷的显微结构也产生影响,ZrO 颗粒以 2 2 3 2“晶内型”和晶界型两种形式存在。合理的配方组成及制备工艺有利于 Z r O 以四方亚稳相存在。Z r O 含量为 2 23 0 w t % 时,其四方相含量可达 6 9 %,有利于应力诱导相变增韧,该 Z T A 复相陶瓷的抗弯强度、断裂韧性分别达到 604MPa、6.87MPa·m1/2。
