The CoO/CoVO/Ni nanocomposites were rationally designed and prepared by a two-step hydrothermal synthesis and subsequent annealing treatment. The one-dimensional（1D） CoOnanowire arrays directly grew on Ni foam, wher...The CoO/CoVO/Ni nanocomposites were rationally designed and prepared by a two-step hydrothermal synthesis and subsequent annealing treatment. The one-dimensional（1D） CoOnanowire arrays directly grew on Ni foam, whereas the 1D CoVOnanowires adhered to parts of CoOnanowires.Most of the hybrid nanowires were inlayed with each other, forming a 3D hybrid nanowires network.As a result, the discharge capacity of CoO/CoVO/Ni nanocomposites could reach 1201.8 mAh/g after100 cycles at 100 mA/g. After 600 cycles at 1 A/g, the discharge capacity was maintained at 828.1 mAh/g.Moreover, even though the charge/discharge rates were increased to 10 A/g, it rendered reversible capacity of 491.2 mAh/g. The superior electrochemical properties of nanocomposites were probably ascribed to their unique 3D architecture and the synergistic effects of two active materials. Therefore, such CoO/CoVO/Ni nanocomposites could potentially be used as anode materials for high-performance Li-ion batteries.展开更多
对不同热处理状态下的微观组织结构进行了研究。采用物理化学相分析技术研究了9Cr13Mo3Co3Nb2V退火、淬火以及最终热处理制度下析出相的类型、含量及组成结构式。并用X射线小角散射(SAXS)(sm all angle x-ray scatter)分析了不同热处理...对不同热处理状态下的微观组织结构进行了研究。采用物理化学相分析技术研究了9Cr13Mo3Co3Nb2V退火、淬火以及最终热处理制度下析出相的类型、含量及组成结构式。并用X射线小角散射(SAXS)(sm all angle x-ray scatter)分析了不同热处理制度下析出相在不同粒度间隔中的质量分布。结果表明:①9Cr13Mo3Co3Nb2V钢退火状态的组织为珠光体+碳化物(M23C6,MC和M6C),淬火状态组织为马氏体+碳化物(M23C6和MC),最终热处理状态的组织为回火马氏体+碳化物(M23C6,MC和M3C);②小颗粒(≤300nm)碳化物析出相粒度分析表明,9Cr13Mo3Co3Nb2V钢退火、淬火状态析出相平均粒度相差不大,粗大颗粒较多,而最终热处理状态的析出相平均粒度明显减小,且细小颗粒比例较大。展开更多
The diffusible hydrogen contents in precharged (Co,Fe) 3V alloy were measured. It is found that atomic ordering can not promote hydrogen penetration in the (Co,Fe) 3V alloy. The ultimate tensile strength (UTS) and duc...The diffusible hydrogen contents in precharged (Co,Fe) 3V alloy were measured. It is found that atomic ordering can not promote hydrogen penetration in the (Co,Fe) 3V alloy. The ultimate tensile strength (UTS) and ductilities in various condition were also investigated. The results show that the UTS and elongation of disordered alloy are higher than that of ordered one with fixed diffusible hydrogen content and (Co,Fe) 3V alloy with ordered structure is highly susceptible to the embrittlement in hydrogen gas. The factor which may affect the susceptibility to the embrittlement of (Co,Fe) 3V alloy in hydrogen gas is mainly due to that the atomic ordering may accelerate the kinetics of the catalytic reaction for the dissociation of molecular hydrogen into atomic hydrogen. However, it can not be roled out that atomic ordering intensifies planar slip and restricts cross slip at the grain boundaries and enhances the susceptibility of the alloy to hydrogen embrittlement.展开更多
基金supported by the National Natural Science Foundation of China(no.51362018)the Foundation for Innovation Groups of Basic Research in Gansu Province(no.1606RJIA322)
文摘The CoO/CoVO/Ni nanocomposites were rationally designed and prepared by a two-step hydrothermal synthesis and subsequent annealing treatment. The one-dimensional（1D） CoOnanowire arrays directly grew on Ni foam, whereas the 1D CoVOnanowires adhered to parts of CoOnanowires.Most of the hybrid nanowires were inlayed with each other, forming a 3D hybrid nanowires network.As a result, the discharge capacity of CoO/CoVO/Ni nanocomposites could reach 1201.8 mAh/g after100 cycles at 100 mA/g. After 600 cycles at 1 A/g, the discharge capacity was maintained at 828.1 mAh/g.Moreover, even though the charge/discharge rates were increased to 10 A/g, it rendered reversible capacity of 491.2 mAh/g. The superior electrochemical properties of nanocomposites were probably ascribed to their unique 3D architecture and the synergistic effects of two active materials. Therefore, such CoO/CoVO/Ni nanocomposites could potentially be used as anode materials for high-performance Li-ion batteries.
文摘对不同热处理状态下的微观组织结构进行了研究。采用物理化学相分析技术研究了9Cr13Mo3Co3Nb2V退火、淬火以及最终热处理制度下析出相的类型、含量及组成结构式。并用X射线小角散射(SAXS)(sm all angle x-ray scatter)分析了不同热处理制度下析出相在不同粒度间隔中的质量分布。结果表明:①9Cr13Mo3Co3Nb2V钢退火状态的组织为珠光体+碳化物(M23C6,MC和M6C),淬火状态组织为马氏体+碳化物(M23C6和MC),最终热处理状态的组织为回火马氏体+碳化物(M23C6,MC和M3C);②小颗粒(≤300nm)碳化物析出相粒度分析表明,9Cr13Mo3Co3Nb2V钢退火、淬火状态析出相平均粒度相差不大,粗大颗粒较多,而最终热处理状态的析出相平均粒度明显减小,且细小颗粒比例较大。
文摘The diffusible hydrogen contents in precharged (Co,Fe) 3V alloy were measured. It is found that atomic ordering can not promote hydrogen penetration in the (Co,Fe) 3V alloy. The ultimate tensile strength (UTS) and ductilities in various condition were also investigated. The results show that the UTS and elongation of disordered alloy are higher than that of ordered one with fixed diffusible hydrogen content and (Co,Fe) 3V alloy with ordered structure is highly susceptible to the embrittlement in hydrogen gas. The factor which may affect the susceptibility to the embrittlement of (Co,Fe) 3V alloy in hydrogen gas is mainly due to that the atomic ordering may accelerate the kinetics of the catalytic reaction for the dissociation of molecular hydrogen into atomic hydrogen. However, it can not be roled out that atomic ordering intensifies planar slip and restricts cross slip at the grain boundaries and enhances the susceptibility of the alloy to hydrogen embrittlement.
