为了在地震资料和裂缝储层特征之间建立联系,对裂缝储层采用了等效介质模型.而传统的等效介质模型未充分考虑非完全弹性介质理论和基于频变各向异性理论的双相或多相流体假设,也不能对实际裂缝储层中的地震波频散和衰减现象提供准确合...为了在地震资料和裂缝储层特征之间建立联系,对裂缝储层采用了等效介质模型.而传统的等效介质模型未充分考虑非完全弹性介质理论和基于频变各向异性理论的双相或多相流体假设,也不能对实际裂缝储层中的地震波频散和衰减现象提供准确合理的解释,并且储层参数的反演研究对裂缝储层的定性预测和定量描述举足轻重.为此,本文首先根据所提出的黏弹性Chapman-Kelvin动态等效介质模型,该模型考虑了耦合的双相流体假设、黏弹性理论、喷射流以及斑块效应,并在此基础上分析了裂缝储层参数(主要为裂缝密度、裂缝长度、孔隙度和含水饱和度)对地震波频变特征的影响.然后基于黏弹性Chapman-Kelvin模型与Schoenberg和Protazio概括的Zoeppritz方程所计算出的频变反射系数,分析了反射PP波和PS波的频变AVAZ(Amplitude Versus Angle and Azimuth)特性和PP波频变反射系数与裂缝储层参数的关系.同时考虑到发生地震频散时,反射系数和频率产生关系,构建了在角度、方位和时间域内的新型正演方程.最后,基于PP波频变反射系数对裂缝密度、裂缝长度、孔隙度和含水饱和度的变化有较好的敏感性特点,进行了两种反演方法研究:其一是基于贝叶斯理论直接反演方法,其中以对数绝对范数作为似然函数和高斯分布,即L2范数度量作为先验约束;其二是基于频变反射系数的MCMC(Markov Chain Monte Carlo)随机反演方法.通过频变AVAZ进行裂缝储层参数的反演研究,结果表明,MCMC随机反演方法在缺失先验的储层参数信息时,反演结果的不确定性较强.当存在有效且足够的先验信息时,反演结果的可靠性进一步提升.而基于贝叶斯理论直接反演方法,则显示出基于频变AVAZ来区别大尺度裂缝和微尺度裂隙的潜力.展开更多
电离层总电子含量TEC(total electron content)是影响卫星导航定位的主要误差源之一。为了构建精确的电离层TEC模型,基于Chapman函数建立了基于物理机制的电离层TEC同化模型背景场,并着重以IGS发布的2008年4个时段低纬度、中纬度和高纬...电离层总电子含量TEC(total electron content)是影响卫星导航定位的主要误差源之一。为了构建精确的电离层TEC模型,基于Chapman函数建立了基于物理机制的电离层TEC同化模型背景场,并着重以IGS发布的2008年4个时段低纬度、中纬度和高纬度地区的电离层TEC数据为样本,同化稀疏点上的已知电离层TEC值,分析模型计算值的残差和相对精度分布,利用模型对电离层TEC进行了2h短期预报和1d预报,并将1d的预报值和IGS发布值进行对比。实验结果表明:(1)由同化模型计算得到的TEC残差值超过92%分布在±2TECU以内,并且除边缘区域外,同化模型TEC计算值的相对精度均在90%以上;(2)2h和1d预报残差小于±3TECU的比例分别为81.8%和81.5%。展开更多
The generalized Chapman-Richards model was derived from the Chapman-Richards function in which parameters h, k and m were unconstrained. Based on the structure of solutions and biological interpretations, the model co...The generalized Chapman-Richards model was derived from the Chapman-Richards function in which parameters h, k and m were unconstrained. Based on the structure of solutions and biological interpretations, the model could be classified into eight cases (three categories) at all and among them only 4 kinds of cases are suitable in forestry that represent four typical growth patterns of trees and stands. For each of 4 equations, the model properties and biological interpretations for parameters were discussed in detail. The generalized Chapman-Richards model was capable of describing a wide range of growth curves that was asymptotic or nonasymptotic, with or without inflection point. In order to illustrate the versatility of the model, it was fitted to a group of data sets concerning the DBH growth of cryptomeria plantations with 4 initial densities and the DBH and height growth of natural Korean pine tree. Comparing the generalized Chapman-Richards function and the Schnute model, it was found that the parameters and expressions of the two models were interchangeable in theory, and the fitting results were explicitly identical in empirical applications.展开更多
The Chapman-Richards Function and its two exception cases in applications were discussed and compared with the Schnute model in stand growth studies. Compared from all perspective, it was found that the Schnute model ...The Chapman-Richards Function and its two exception cases in applications were discussed and compared with the Schnute model in stand growth studies. Compared from all perspective, it was found that the Schnute model commonly used in foreitry was identical to the Chapman-Richards function. If some parameter in the Chapman-Richdrds Function was unconstraint, the function could also be very versatile to fit some exceptional growth curves, the fitted function should be identical to that the Schnute model.展开更多
In this paper,the Chapman-Richards model is adapted to best fit three types of nonlinear curves that are generally encountered in geotechnical engineering practices,i.e.the degree of consolidation versus time factor c...In this paper,the Chapman-Richards model is adapted to best fit three types of nonlinear curves that are generally encountered in geotechnical engineering practices,i.e.the degree of consolidation versus time factor curves in one-dimensional consolidation and plane strain consolidation under strip loading,the compressibility and permeability curves of soft clay,and the geometry parameters of geosynthetic tube versus pumping pressure curves.The methods of determining unknown parameters using the Chapman-Richards model are fully demonstrated.It is found that the Chapman-Richards model has its range of applications in geotechnical engineering and may provide unique insights into the complexity of geotechnical problems.展开更多
The resolution by Chen and Sun of divergent Chapman-Enskog expansion problem will not only build a unified foundation for non-equilibrium dynamics modeling at all Mach number and Knudsen number, but also shed light to...The resolution by Chen and Sun of divergent Chapman-Enskog expansion problem will not only build a unified foundation for non-equilibrium dynamics modeling at all Mach number and Knudsen number, but also shed light to a large class of difficult theoretical problems involving divergent expansion on strong nonlinearity.展开更多
文摘为了在地震资料和裂缝储层特征之间建立联系,对裂缝储层采用了等效介质模型.而传统的等效介质模型未充分考虑非完全弹性介质理论和基于频变各向异性理论的双相或多相流体假设,也不能对实际裂缝储层中的地震波频散和衰减现象提供准确合理的解释,并且储层参数的反演研究对裂缝储层的定性预测和定量描述举足轻重.为此,本文首先根据所提出的黏弹性Chapman-Kelvin动态等效介质模型,该模型考虑了耦合的双相流体假设、黏弹性理论、喷射流以及斑块效应,并在此基础上分析了裂缝储层参数(主要为裂缝密度、裂缝长度、孔隙度和含水饱和度)对地震波频变特征的影响.然后基于黏弹性Chapman-Kelvin模型与Schoenberg和Protazio概括的Zoeppritz方程所计算出的频变反射系数,分析了反射PP波和PS波的频变AVAZ(Amplitude Versus Angle and Azimuth)特性和PP波频变反射系数与裂缝储层参数的关系.同时考虑到发生地震频散时,反射系数和频率产生关系,构建了在角度、方位和时间域内的新型正演方程.最后,基于PP波频变反射系数对裂缝密度、裂缝长度、孔隙度和含水饱和度的变化有较好的敏感性特点,进行了两种反演方法研究:其一是基于贝叶斯理论直接反演方法,其中以对数绝对范数作为似然函数和高斯分布,即L2范数度量作为先验约束;其二是基于频变反射系数的MCMC(Markov Chain Monte Carlo)随机反演方法.通过频变AVAZ进行裂缝储层参数的反演研究,结果表明,MCMC随机反演方法在缺失先验的储层参数信息时,反演结果的不确定性较强.当存在有效且足够的先验信息时,反演结果的可靠性进一步提升.而基于贝叶斯理论直接反演方法,则显示出基于频变AVAZ来区别大尺度裂缝和微尺度裂隙的潜力.
文摘电离层总电子含量TEC(total electron content)是影响卫星导航定位的主要误差源之一。为了构建精确的电离层TEC模型,基于Chapman函数建立了基于物理机制的电离层TEC同化模型背景场,并着重以IGS发布的2008年4个时段低纬度、中纬度和高纬度地区的电离层TEC数据为样本,同化稀疏点上的已知电离层TEC值,分析模型计算值的残差和相对精度分布,利用模型对电离层TEC进行了2h短期预报和1d预报,并将1d的预报值和IGS发布值进行对比。实验结果表明:(1)由同化模型计算得到的TEC残差值超过92%分布在±2TECU以内,并且除边缘区域外,同化模型TEC计算值的相对精度均在90%以上;(2)2h和1d预报残差小于±3TECU的比例分别为81.8%和81.5%。
基金This research was supported by Excellent Youth Teacher Project of Ministry of Education.
文摘The generalized Chapman-Richards model was derived from the Chapman-Richards function in which parameters h, k and m were unconstrained. Based on the structure of solutions and biological interpretations, the model could be classified into eight cases (three categories) at all and among them only 4 kinds of cases are suitable in forestry that represent four typical growth patterns of trees and stands. For each of 4 equations, the model properties and biological interpretations for parameters were discussed in detail. The generalized Chapman-Richards model was capable of describing a wide range of growth curves that was asymptotic or nonasymptotic, with or without inflection point. In order to illustrate the versatility of the model, it was fitted to a group of data sets concerning the DBH growth of cryptomeria plantations with 4 initial densities and the DBH and height growth of natural Korean pine tree. Comparing the generalized Chapman-Richards function and the Schnute model, it was found that the parameters and expressions of the two models were interchangeable in theory, and the fitting results were explicitly identical in empirical applications.
文摘The Chapman-Richards Function and its two exception cases in applications were discussed and compared with the Schnute model in stand growth studies. Compared from all perspective, it was found that the Schnute model commonly used in foreitry was identical to the Chapman-Richards function. If some parameter in the Chapman-Richdrds Function was unconstraint, the function could also be very versatile to fit some exceptional growth curves, the fitted function should be identical to that the Schnute model.
文摘In this paper,the Chapman-Richards model is adapted to best fit three types of nonlinear curves that are generally encountered in geotechnical engineering practices,i.e.the degree of consolidation versus time factor curves in one-dimensional consolidation and plane strain consolidation under strip loading,the compressibility and permeability curves of soft clay,and the geometry parameters of geosynthetic tube versus pumping pressure curves.The methods of determining unknown parameters using the Chapman-Richards model are fully demonstrated.It is found that the Chapman-Richards model has its range of applications in geotechnical engineering and may provide unique insights into the complexity of geotechnical problems.
文摘The resolution by Chen and Sun of divergent Chapman-Enskog expansion problem will not only build a unified foundation for non-equilibrium dynamics modeling at all Mach number and Knudsen number, but also shed light to a large class of difficult theoretical problems involving divergent expansion on strong nonlinearity.
