The effect of bainite morphology on mechanical properties of the mixed bainite-martensite microstructure in D6AC low alloy ultra-high strength steel has been studied in the present work. For this purpose, samples aust...The effect of bainite morphology on mechanical properties of the mixed bainite-martensite microstructure in D6AC low alloy ultra-high strength steel has been studied in the present work. For this purpose, samples austenitized at 910℃ for 40 min were quenched in three different ways. Some of the samples were directly oil-quenched, some others were quenched in salt bath at 330 ℃ and the remaining samples were quenched in salt bath at 425 ℃ for various holding times. All samples were tempered at 200 ℃ for 2 h. Microstructures were examined by optical microscopy （OM） and scanning electron microscopy （SEM）. Fracture surfaces also were studied by SEM. Results showed that the mixed microstructure containing martensite and 28 vol.% of the lower bainite exhibited higher yield and tensile strengths than the fully martensitic microstructure. This could be mainly attributed to the partitioning of the prior austenite grains by the lower bainite and enhancing the strength of lower bainite in the mixed microstructure by plastic constraint. Charpy V-notch （CVN） impact energy and ductility were improved by increasing the volume fraction of the lower bainite. This is not the case about the mixed microstructure containing the upper bainite and martensite. As a result, the tensile and CVN impact properties of mixed upper bainite-martensite microstructure are lower than those of the fully martensitic microstructure. Finally, fractography studies showed cleavage fracture at the surface of CVN impact specimens with martensitic and upper bainitic microstructures confirming the tendency to brittle behavior.展开更多
文摘The effect of bainite morphology on mechanical properties of the mixed bainite-martensite microstructure in D6AC low alloy ultra-high strength steel has been studied in the present work. For this purpose, samples austenitized at 910℃ for 40 min were quenched in three different ways. Some of the samples were directly oil-quenched, some others were quenched in salt bath at 330 ℃ and the remaining samples were quenched in salt bath at 425 ℃ for various holding times. All samples were tempered at 200 ℃ for 2 h. Microstructures were examined by optical microscopy （OM） and scanning electron microscopy （SEM）. Fracture surfaces also were studied by SEM. Results showed that the mixed microstructure containing martensite and 28 vol.% of the lower bainite exhibited higher yield and tensile strengths than the fully martensitic microstructure. This could be mainly attributed to the partitioning of the prior austenite grains by the lower bainite and enhancing the strength of lower bainite in the mixed microstructure by plastic constraint. Charpy V-notch （CVN） impact energy and ductility were improved by increasing the volume fraction of the lower bainite. This is not the case about the mixed microstructure containing the upper bainite and martensite. As a result, the tensile and CVN impact properties of mixed upper bainite-martensite microstructure are lower than those of the fully martensitic microstructure. Finally, fractography studies showed cleavage fracture at the surface of CVN impact specimens with martensitic and upper bainitic microstructures confirming the tendency to brittle behavior.
