In this paper, a new idea of reconfigurable 3/6 dB branch line coupler is proposed. The proposed coupler is tuned through a simple open and short circuit at the coupler’s branches’ edges. At the short edges case, a ...In this paper, a new idea of reconfigurable 3/6 dB branch line coupler is proposed. The proposed coupler is tuned through a simple open and short circuit at the coupler’s branches’ edges. At the short edges case, a 3 dB branch line coupler is obtained. In this case, the coupler’s branches are considered as microstrip transmission lines with 0.3 mm slot width which is etched in each coupler’s branch. At the open edges case, the coupler’s branches are considered as asymmetric coupled microstrip lines. In this case, a 6 dB branch line coupler is obtained. Both CST and IE3D simulators are used to optimize the reconfigurable 3/6 dB branch line coupler dimensions. As a prototypes, two BLCs are designed, analyzed and tested at the “on” and “off” states at 2.5 GHz. The measured S-parameters confirm the proposed concept of the reconfigurable 3/6 dB branch line coupler.展开更多
The third damage action,human disruption behavior,is one of the major threats to pipeline operation.It is necessary to monitor and locate the perturbation behavior that may threat pipeline safety in real-time.Therefor...The third damage action,human disruption behavior,is one of the major threats to pipeline operation.It is necessary to monitor and locate the perturbation behavior that may threat pipeline safety in real-time.Therefore,a new pipeline security monitoring system is designed by using line-structure Sagnac optic fiber interferemeter with the characteristic of 3×3coupler that can modulate the phase of optic signal,with no need for phase modulation and demodulation.The optic structure of the new system is simplified,the signal processing accuracy is improved,and the polarization effect is reduced.The working principle of the monitoring in ideal condition is described,the phase demodulation is analyzed and the location of the possible damage action point is formulated.By using simulink,the optic signal propagation and interference is simulated and interference signals in different frequencies are obtained.The results validate the feasibility of the monitoring system and indicate that the low frequency signal less than 1kHz resulting from the human damage action can be detected.The disturbance set at 10 km can be located by calculating the demodulation signal accurately over a long monitoring distance.展开更多
为了实现分布反馈式光纤激光传感器(DFB FL)大动态范围、稳定解调,建立了基于3×3耦合器的迈克尔逊干涉仪解调系统。对该系统所采用的对称解调算法(NPS)和反正切解调算法进行了深入研究。首先,介绍了基于3×3耦合器解调算法的...为了实现分布反馈式光纤激光传感器(DFB FL)大动态范围、稳定解调,建立了基于3×3耦合器的迈克尔逊干涉仪解调系统。对该系统所采用的对称解调算法(NPS)和反正切解调算法进行了深入研究。首先,介绍了基于3×3耦合器解调算法的原理及耦合器不对称时的调校方法。接着,对干涉仪所需最小非平衡路径长度的选取与系统强度噪声、激光器频率噪声的关系进行了分析。最后,针对NPS算法与反正切算法最大可解调信号幅度进行了分析对比,并研究了微分器对对称解调方法解调范围的影响。实验结果表明:NPS算法动态范围高于反正切算法,微分器的幅频特性不理想会减小解调动态范围。在采样频率为125 k Hz、信号频率为1 k Hz、干涉仪非平衡路径为100 m时,NPS算法与反正切算法的动态范围分别达到96 d B和90 d B。用解调前调校的方法,基于3×3耦合的解调方法动态范围大,能够实现稳定解调,满足工程应用要求。展开更多
文摘In this paper, a new idea of reconfigurable 3/6 dB branch line coupler is proposed. The proposed coupler is tuned through a simple open and short circuit at the coupler’s branches’ edges. At the short edges case, a 3 dB branch line coupler is obtained. In this case, the coupler’s branches are considered as microstrip transmission lines with 0.3 mm slot width which is etched in each coupler’s branch. At the open edges case, the coupler’s branches are considered as asymmetric coupled microstrip lines. In this case, a 6 dB branch line coupler is obtained. Both CST and IE3D simulators are used to optimize the reconfigurable 3/6 dB branch line coupler dimensions. As a prototypes, two BLCs are designed, analyzed and tested at the “on” and “off” states at 2.5 GHz. The measured S-parameters confirm the proposed concept of the reconfigurable 3/6 dB branch line coupler.
基金supported by the National Natural Science Foundation of China (No.51235001)the Beijing Natural Science Foundation(No.1122005)
文摘The third damage action,human disruption behavior,is one of the major threats to pipeline operation.It is necessary to monitor and locate the perturbation behavior that may threat pipeline safety in real-time.Therefore,a new pipeline security monitoring system is designed by using line-structure Sagnac optic fiber interferemeter with the characteristic of 3×3coupler that can modulate the phase of optic signal,with no need for phase modulation and demodulation.The optic structure of the new system is simplified,the signal processing accuracy is improved,and the polarization effect is reduced.The working principle of the monitoring in ideal condition is described,the phase demodulation is analyzed and the location of the possible damage action point is formulated.By using simulink,the optic signal propagation and interference is simulated and interference signals in different frequencies are obtained.The results validate the feasibility of the monitoring system and indicate that the low frequency signal less than 1kHz resulting from the human damage action can be detected.The disturbance set at 10 km can be located by calculating the demodulation signal accurately over a long monitoring distance.
文摘为了实现分布反馈式光纤激光传感器(DFB FL)大动态范围、稳定解调,建立了基于3×3耦合器的迈克尔逊干涉仪解调系统。对该系统所采用的对称解调算法(NPS)和反正切解调算法进行了深入研究。首先,介绍了基于3×3耦合器解调算法的原理及耦合器不对称时的调校方法。接着,对干涉仪所需最小非平衡路径长度的选取与系统强度噪声、激光器频率噪声的关系进行了分析。最后,针对NPS算法与反正切算法最大可解调信号幅度进行了分析对比,并研究了微分器对对称解调方法解调范围的影响。实验结果表明:NPS算法动态范围高于反正切算法,微分器的幅频特性不理想会减小解调动态范围。在采样频率为125 k Hz、信号频率为1 k Hz、干涉仪非平衡路径为100 m时,NPS算法与反正切算法的动态范围分别达到96 d B和90 d B。用解调前调校的方法,基于3×3耦合的解调方法动态范围大,能够实现稳定解调,满足工程应用要求。
