This paper presents a 220-GHz-band 7-m wireless link with a 45-Gbps transmission data rate by using 16 quadrature amplitude modulation(16-QAM).Super-heterodyne transceiver modules are developed for transmission and re...This paper presents a 220-GHz-band 7-m wireless link with a 45-Gbps transmission data rate by using 16 quadrature amplitude modulation(16-QAM).Super-heterodyne transceiver modules are developed for transmission and reception of the modulated signals,which consist of a Schottky barrier diodes(SBD)based sub-harmonic mixer(SHM),an InP HEMT low noise amplifier(LNA),a waveguide band-pass filter(BPF),and a 108-GHz local oscillator(LO)multiplier chain.The transmitter features a peak transmit power of 1.41 dBm,and the IF frequency varies from 5 GHz to 20 GHz.Besides,the receiver features a conversion gain of 9.3 dB in average and a noise temperature of 3052.8 K.The measured results indicate that the transceiver modules enable data transmission of a 45-Gbps 16-QAM signal with Signal-Noise-Ratio(SNR)from 11.59 dB to 15.36 dB in a 7-m line-of-sight channel.展开更多
Nyquist wavelength-division multiplexing （N-WDM） allows high spectral efficiency （SE） in long-haul transmission systems. Compared to polarization-division multiplexing quadrature phase-shift keying （PDM-QPSK）, m...Nyquist wavelength-division multiplexing （N-WDM） allows high spectral efficiency （SE） in long-haul transmission systems. Compared to polarization-division multiplexing quadrature phase-shift keying （PDM-QPSK）, multilevel modulation, such as PDM 16 quadrature-amplitude modulation （16-QAM）, is much more sensitive to intrachannel noise and interchannel linear crosstalk caused by N-WDM. We experimentally generate and transmit a 6 x 128 Gbit/s N-WDM PDM 16-QAM signal over 1200 km single-mode fiber （SMF）-28 with amplification provided by an erbium-doped fiber amplifier （EDFA） only. The net SE is 7.47 bit/s/Hz, which to the best of our knowledge is the highest SE for a signal with a bit rate beyond 100 Gbit/s using the PDM 16-QAM. Such SE was achieved by DSP pre-equalization of transmitter-side impairments and DSP post-equalization of channel and receiver-side impairments. Nyquist-band can be used in pre-equalization to enhance the tolerance of PDM 16-QAM to aggressive spectral shaping. The bit-error ratio （BER） for each of the 6 channels is smaller than the forward error correction （FEC） limit of 3.8 × 10-3 after 1200 km SMF-28 transmission.展开更多
The BER performance for an optimal circular 16-QAM constellation is theoretically derived and applied in wavelet based OFDM system in additive white Gaussian noise channel. Signal point constellations have been discus...The BER performance for an optimal circular 16-QAM constellation is theoretically derived and applied in wavelet based OFDM system in additive white Gaussian noise channel. Signal point constellations have been discussed in much literature. An optimal circular 16-QAM is developed. The calculation of the BER is based on the four types of the decision boundaries. Each decision boundary is determined based on the space distance d following the pdf Gaussian distribution with respect to the in-phase and quadrature components nI and nQ with the assumption that they are statistically independent to each other. The BER analysis for other circular M-ary QAM is also analyzed. The system is then applied to wavelet based OFDM. The wavelet transform is considered because it offers a better spectral containment feature compared to conventional OFDM using Fourier transform. The circular schemes are slightly better than the square schemes in most SNR values. All simulation results have met the theoretical calculations. When applying to wavelet based OFDM, the circular modulation scheme has also performed slightly less errors as compared to the square modulation scheme.展开更多
A polarization-diversity loop with a silicon waveguide with a lateral p-i-n diode as a nonlinear medium is used to realize polarization insensitive four-wave mixing. Wavelength conversion of seven dual-polarization 16...A polarization-diversity loop with a silicon waveguide with a lateral p-i-n diode as a nonlinear medium is used to realize polarization insensitive four-wave mixing. Wavelength conversion of seven dual-polarization 16-quadrature amplitude modulation(QAM) signals at 16 GBd is demonstrated with an optical signal-to-noise ratio penalty below 0.7 dB. High-quality converted signals are generated thanks to the low polarization dependence(≤0.5 dB) and the high conversion efficiency(CE) achievable. The strong Kerr nonlinearity in silicon and the decrease of detrimental free-carrier absorption due to the reverse-biased p-i-n diode are key in ensuring high CE levels.展开更多
Non-uniform step-size distribution is implemented for split-step based nonlinear compensation in singlechannel 112-Gb/s 16 quadrature amplitude modulation （QAM） transmission. Numerical simulations of the system incl...Non-uniform step-size distribution is implemented for split-step based nonlinear compensation in singlechannel 112-Gb/s 16 quadrature amplitude modulation （QAM） transmission. Numerical simulations of the system including a 20 × 80 km uncompensated link are performed using logarithmic step size distribution to compensate signal distortions. 50% of reduction in number of steps with respect to using constant step sizes is observed. The performance is further improved by optimizing nonlinear calculating position （NLCP） in case of using constant step sizes while NLCP optimization becomes unnecessary when using logarithmic step sizes, which reduces the computational effort due to uniformly distributed nonlinear phase for all successive steps.展开更多
由于MATLAB/Simulink本身就是一款优秀的系统建模和算法仿真工具,Modelsim是国内最为常用的HDL仿真工具,利用Link for modelsim使Modelsim与Simulink协同工作,使得算法设计和验证在同一款软件中完成。避免了不同开发环境下的兼容性问题...由于MATLAB/Simulink本身就是一款优秀的系统建模和算法仿真工具,Modelsim是国内最为常用的HDL仿真工具,利用Link for modelsim使Modelsim与Simulink协同工作,使得算法设计和验证在同一款软件中完成。避免了不同开发环境下的兼容性问题,极大地简化了设计的复杂度,加快了开发进程。提出利用基于模型的设计方法,可以将算法与硬件实现联合起来,对于算法的开发以及后期硬件实现都会带来极大的方便。详细介绍了Modelsim与MATLAB/Simulink联合仿真的接口技术、模型的搭建,以及通过利用16 QAM调制与解调的应用实例来验证系统的正确性。展开更多
基金National Natural Science Foundation of China(No.61871072).
文摘This paper presents a 220-GHz-band 7-m wireless link with a 45-Gbps transmission data rate by using 16 quadrature amplitude modulation(16-QAM).Super-heterodyne transceiver modules are developed for transmission and reception of the modulated signals,which consist of a Schottky barrier diodes(SBD)based sub-harmonic mixer(SHM),an InP HEMT low noise amplifier(LNA),a waveguide band-pass filter(BPF),and a 108-GHz local oscillator(LO)multiplier chain.The transmitter features a peak transmit power of 1.41 dBm,and the IF frequency varies from 5 GHz to 20 GHz.Besides,the receiver features a conversion gain of 9.3 dB in average and a noise temperature of 3052.8 K.The measured results indicate that the transceiver modules enable data transmission of a 45-Gbps 16-QAM signal with Signal-Noise-Ratio(SNR)from 11.59 dB to 15.36 dB in a 7-m line-of-sight channel.
文摘Nyquist wavelength-division multiplexing （N-WDM） allows high spectral efficiency （SE） in long-haul transmission systems. Compared to polarization-division multiplexing quadrature phase-shift keying （PDM-QPSK）, multilevel modulation, such as PDM 16 quadrature-amplitude modulation （16-QAM）, is much more sensitive to intrachannel noise and interchannel linear crosstalk caused by N-WDM. We experimentally generate and transmit a 6 x 128 Gbit/s N-WDM PDM 16-QAM signal over 1200 km single-mode fiber （SMF）-28 with amplification provided by an erbium-doped fiber amplifier （EDFA） only. The net SE is 7.47 bit/s/Hz, which to the best of our knowledge is the highest SE for a signal with a bit rate beyond 100 Gbit/s using the PDM 16-QAM. Such SE was achieved by DSP pre-equalization of transmitter-side impairments and DSP post-equalization of channel and receiver-side impairments. Nyquist-band can be used in pre-equalization to enhance the tolerance of PDM 16-QAM to aggressive spectral shaping. The bit-error ratio （BER） for each of the 6 channels is smaller than the forward error correction （FEC） limit of 3.8 × 10-3 after 1200 km SMF-28 transmission.
文摘The BER performance for an optimal circular 16-QAM constellation is theoretically derived and applied in wavelet based OFDM system in additive white Gaussian noise channel. Signal point constellations have been discussed in much literature. An optimal circular 16-QAM is developed. The calculation of the BER is based on the four types of the decision boundaries. Each decision boundary is determined based on the space distance d following the pdf Gaussian distribution with respect to the in-phase and quadrature components nI and nQ with the assumption that they are statistically independent to each other. The BER analysis for other circular M-ary QAM is also analyzed. The system is then applied to wavelet based OFDM. The wavelet transform is considered because it offers a better spectral containment feature compared to conventional OFDM using Fourier transform. The circular schemes are slightly better than the square schemes in most SNR values. All simulation results have met the theoretical calculations. When applying to wavelet based OFDM, the circular modulation scheme has also performed slightly less errors as compared to the square modulation scheme.
文摘A polarization-diversity loop with a silicon waveguide with a lateral p-i-n diode as a nonlinear medium is used to realize polarization insensitive four-wave mixing. Wavelength conversion of seven dual-polarization 16-quadrature amplitude modulation(QAM) signals at 16 GBd is demonstrated with an optical signal-to-noise ratio penalty below 0.7 dB. High-quality converted signals are generated thanks to the low polarization dependence(≤0.5 dB) and the high conversion efficiency(CE) achievable. The strong Kerr nonlinearity in silicon and the decrease of detrimental free-carrier absorption due to the reverse-biased p-i-n diode are key in ensuring high CE levels.
基金funding of the Erlangen Graduate School in Advanced Optical Technologies (SAOT) by the German National Science Foundation(DFG) in the framework of the excellence initiative
文摘Non-uniform step-size distribution is implemented for split-step based nonlinear compensation in singlechannel 112-Gb/s 16 quadrature amplitude modulation （QAM） transmission. Numerical simulations of the system including a 20 × 80 km uncompensated link are performed using logarithmic step size distribution to compensate signal distortions. 50% of reduction in number of steps with respect to using constant step sizes is observed. The performance is further improved by optimizing nonlinear calculating position （NLCP） in case of using constant step sizes while NLCP optimization becomes unnecessary when using logarithmic step sizes, which reduces the computational effort due to uniformly distributed nonlinear phase for all successive steps.
文摘由于MATLAB/Simulink本身就是一款优秀的系统建模和算法仿真工具,Modelsim是国内最为常用的HDL仿真工具,利用Link for modelsim使Modelsim与Simulink协同工作,使得算法设计和验证在同一款软件中完成。避免了不同开发环境下的兼容性问题,极大地简化了设计的复杂度,加快了开发进程。提出利用基于模型的设计方法,可以将算法与硬件实现联合起来,对于算法的开发以及后期硬件实现都会带来极大的方便。详细介绍了Modelsim与MATLAB/Simulink联合仿真的接口技术、模型的搭建,以及通过利用16 QAM调制与解调的应用实例来验证系统的正确性。
