The electrochemical methanol oxidation reaction(MOR) is of paramount importance for direct methanol fuel cell(DMFC) application, where efficient catalysts are required to facilitate the complicated multiple charge tra...The electrochemical methanol oxidation reaction(MOR) is of paramount importance for direct methanol fuel cell(DMFC) application, where efficient catalysts are required to facilitate the complicated multiple charge transfer process. The catalyst support not only determines the dispersion status of the catalysts particles, but also exerts great influence on the electronic structure of the catalysts, thereby altering its intrinsic activity. Herein, we demonstrated that nitrogen atoms, assisted by the pre-treatment of carbon matrix with oxidants, can be easily doped into carbon nanotubes at low temperature. The obtained nitrogen-doped carbon nanotubes can effectively improve the dispersion of the supported platinum nanoparticles and facilitate the MOR by modifying the electronic structure of platinum atoms,through catalyst-support interaction.展开更多
A series of pre-reduced LaMn1–xCuxO3 (0≤x<1) catalysts for methanol synthesis from CO2 hydrogenation were prepared by a sol-gel method. The catalytic performances were strongly dependent on the copper content. XR...A series of pre-reduced LaMn1–xCuxO3 (0≤x<1) catalysts for methanol synthesis from CO2 hydrogenation were prepared by a sol-gel method. The catalytic performances were strongly dependent on the copper content. XRD investigation revealed that the single perovskite structure could be preserved after being reduced, when the substitution for Mn by Cu was less than 50%. The Cu-doped (x=0.5) LaMnO3 was much more active than the other catalysts for reaction, showing CO2 conversion up to 11.33% and methanol sele...展开更多
Supported PtRu/C catalysts used in direct methanol fuel cells (DMFCs) were prepared by a new modified polyol method. Transmission electron microscopy (TEM), X-ray diffraction (XRD) and cyclic voltammograms (CVs) were ...Supported PtRu/C catalysts used in direct methanol fuel cells (DMFCs) were prepared by a new modified polyol method. Transmission electron microscopy (TEM), X-ray diffraction (XRD) and cyclic voltammograms (CVs) were carried out to characterize the morphology, composition and the electrochemical properties of the PtRu/C catalyst. The results revealed that the PtRu nanoparticles with small average particle size (≈2.5 nm), and highly dispersed on the carbon support. The PtRu/C catalyst exhibited high catalytic activity and anti poisoned performance than that of the JM PtRu/C. It is imply that the modified polyol method is efficient for PtRu/C catalyst preparation.展开更多
During the Folin Ciocalteu (F-C) micro-assay for the determination of phenolics in the presence of methanol, fine solids can form. In a previous paper, we hypothesized that the interference from alcohol on the F-C rea...During the Folin Ciocalteu (F-C) micro-assay for the determination of phenolics in the presence of methanol, fine solids can form. In a previous paper, we hypothesized that the interference from alcohol on the F-C reaction can be minimized depending on the particular procedure used to reach the alkalinity condition. In order to demonstrate our hypothesis we studied, by spectrophotometrically monitoring, the time-behaviour of the reactions carried out in the presence of different methanol concentrations at the same alkalinity condition from two protocols. The results showed that the interfering effect of methanol on the F-C micro-method can be affect and even prevented depending on working conditions. In particular, the formation of fine solids can be delayed, slowed down and prevented depending on the initial carbonate concentration used. We have explained why the initial carbonate concentration, used to reach the final alkalinity condition, plays an important role in the F-C reaction carried out in the presence of methanol. Moreover, the results from real-time monitoring showed that, differently from traditional F-C procedure, our procedure allows us to carry out the F-C micro method in the presence of 6% methanol, as an extreme concentration, reading the absorbance at real time 24 min. The real-time monitoring of absorbance can be considered as a useful means to explore the effect of other parameters on precipitate formation caused by the presence of methanol in the F-C reaction.展开更多
Sulfonated polyether ether ketone （SPEEK） based composite membranes for direct methanol fuel cell （DMFC） application were prepared by sol-gel reaction of tetraethoxysilane （TEOS） in the SPEEK matrix and the inco...Sulfonated polyether ether ketone （SPEEK） based composite membranes for direct methanol fuel cell （DMFC） application were prepared by sol-gel reaction of tetraethoxysilane （TEOS） in the SPEEK matrix and the incorporation of phosphotungstic acid （PWA）.The conductivity of the developed membranes was determined by impedance spectroscopy and the methanol permeability through the membranes was obtained from diffuseness experiments.The SEM images show that the addition of SiO2 and the covalent cross-linking structure lead to fine PWA particles and more uniformly dispersion.The swelling of composite membranes remains in the range of 5%-8% at 30-90 ℃ and the effusion of PWA reduces significantly.The composite membranes show a good balance in higher proton conductivity and lower methanol permeation.The cell with composite membrane has higher open circuit voltage（0.728 V） and higher peak power density（45 mW/cm2） than that with Nafion117.展开更多
基金supported by the National Natural Science Foundation of China (21433003, 21633008)the Jilin Province Science and Technology Development Program (20150101066JC, 20160622037JC, 20170203003SF, and 20170520150JH)the Hundred Talents Program of the Chinese Academy of Sciences and the Recruitment Program of Foreign Experts (WQ20122200077)
文摘The electrochemical methanol oxidation reaction(MOR) is of paramount importance for direct methanol fuel cell(DMFC) application, where efficient catalysts are required to facilitate the complicated multiple charge transfer process. The catalyst support not only determines the dispersion status of the catalysts particles, but also exerts great influence on the electronic structure of the catalysts, thereby altering its intrinsic activity. Herein, we demonstrated that nitrogen atoms, assisted by the pre-treatment of carbon matrix with oxidants, can be easily doped into carbon nanotubes at low temperature. The obtained nitrogen-doped carbon nanotubes can effectively improve the dispersion of the supported platinum nanoparticles and facilitate the MOR by modifying the electronic structure of platinum atoms,through catalyst-support interaction.
文摘A series of pre-reduced LaMn1–xCuxO3 (0≤x<1) catalysts for methanol synthesis from CO2 hydrogenation were prepared by a sol-gel method. The catalytic performances were strongly dependent on the copper content. XRD investigation revealed that the single perovskite structure could be preserved after being reduced, when the substitution for Mn by Cu was less than 50%. The Cu-doped (x=0.5) LaMnO3 was much more active than the other catalysts for reaction, showing CO2 conversion up to 11.33% and methanol sele...
文摘Supported PtRu/C catalysts used in direct methanol fuel cells (DMFCs) were prepared by a new modified polyol method. Transmission electron microscopy (TEM), X-ray diffraction (XRD) and cyclic voltammograms (CVs) were carried out to characterize the morphology, composition and the electrochemical properties of the PtRu/C catalyst. The results revealed that the PtRu nanoparticles with small average particle size (≈2.5 nm), and highly dispersed on the carbon support. The PtRu/C catalyst exhibited high catalytic activity and anti poisoned performance than that of the JM PtRu/C. It is imply that the modified polyol method is efficient for PtRu/C catalyst preparation.
文摘During the Folin Ciocalteu (F-C) micro-assay for the determination of phenolics in the presence of methanol, fine solids can form. In a previous paper, we hypothesized that the interference from alcohol on the F-C reaction can be minimized depending on the particular procedure used to reach the alkalinity condition. In order to demonstrate our hypothesis we studied, by spectrophotometrically monitoring, the time-behaviour of the reactions carried out in the presence of different methanol concentrations at the same alkalinity condition from two protocols. The results showed that the interfering effect of methanol on the F-C micro-method can be affect and even prevented depending on working conditions. In particular, the formation of fine solids can be delayed, slowed down and prevented depending on the initial carbonate concentration used. We have explained why the initial carbonate concentration, used to reach the final alkalinity condition, plays an important role in the F-C reaction carried out in the presence of methanol. Moreover, the results from real-time monitoring showed that, differently from traditional F-C procedure, our procedure allows us to carry out the F-C micro method in the presence of 6% methanol, as an extreme concentration, reading the absorbance at real time 24 min. The real-time monitoring of absorbance can be considered as a useful means to explore the effect of other parameters on precipitate formation caused by the presence of methanol in the F-C reaction.
基金Funded by Ministry of Education, Hubei, China (No.Q20091403)
文摘Sulfonated polyether ether ketone （SPEEK） based composite membranes for direct methanol fuel cell （DMFC） application were prepared by sol-gel reaction of tetraethoxysilane （TEOS） in the SPEEK matrix and the incorporation of phosphotungstic acid （PWA）.The conductivity of the developed membranes was determined by impedance spectroscopy and the methanol permeability through the membranes was obtained from diffuseness experiments.The SEM images show that the addition of SiO2 and the covalent cross-linking structure lead to fine PWA particles and more uniformly dispersion.The swelling of composite membranes remains in the range of 5%-8% at 30-90 ℃ and the effusion of PWA reduces significantly.The composite membranes show a good balance in higher proton conductivity and lower methanol permeation.The cell with composite membrane has higher open circuit voltage（0.728 V） and higher peak power density（45 mW/cm2） than that with Nafion117.
