In traditional in situ polymerization preparation for solid-state electrolytes,initiators are directly added to the liquid precursor.In this article,a novel cellulose paper-based composite separator is fabricated,whic...In traditional in situ polymerization preparation for solid-state electrolytes,initiators are directly added to the liquid precursor.In this article,a novel cellulose paper-based composite separator is fabricated,which employs alumina as the inorganic reinforcing material and is loaded with polymerization initiator aluminum trifluoromethanesulfonate.Based upon this,a separator-induced in situ directional polymerization technique is demonstrated,and the extra addition of initiators into liquid precursors is no longer required.The polymerization starts from the surface and interior of the separator and extends outward with the gradually dissolving of initiators into the precursor.Compared with its traditional counterpart,the separator-induced poly(1,3-dioxolane)electrolyte shows improved interfacial contact as well as appropriately mitigated polymerization rate,which are conducive to practical applications.Electrochemical measurement results show that the prepared poly(1,3-dioxolane)solid electrolyte possesses an oxidation potential up to 4.4 V and a high Li+transference number of 0.72.After 1000 cycles at 2 C rate(340 mA g^(−1)),the assembled Li||LiFePO_(4)solid battery possesses a 106.8 mAh g^(−1)discharge capacity retention and 83.5%capacity retention ratio,with high average Coulombic efficiency of 99.5%achieved.Our work may provide new ideas for the design and application of in situ polymerization technique for solid electrolytes and solid batteries.展开更多
The influence of the electronic and steric properties of bromoaromatic substrates on direct arylation polymerization for synthesizing high-molecular-weight conjugated polymers was investigated through a combination of...The influence of the electronic and steric properties of bromoaromatic substrates on direct arylation polymerization for synthesizing high-molecular-weight conjugated polymers was investigated through a combination of experiments and calculations.Bromo-aromatic substrates with electron-withdrawing fluoro substituents exhibited higher yields and degrees of polymerization under PPh3-assisted conditions compared to those with electron-donating or bulky methyl substituents.Additionally,excessive steric hindrance at ortho-sites or overly electrondeficient dibromoaromatic substrates leads to reaction inactivation.Calculations indicated that electron-withdrawing substituents enhanced the electrophilicity of arylpalladium-PPh3intermediates,facilitating the activation of electron-rich arylative substrates and promoting polymer growth.Furthermore,steric hindrance from the substituents can influence the preferred reaction pathway,thereby increasing the real reaction barriers.Both experimental and computational results suggest that bromoaromatic substrates with optimized electron-deficient characteristics significantly improve monomer conversion and polymerization efficiency with n-hexylmethylether-substituted EDOT.These findings clarify how the electronic and steric properties of bromo-aromatic substrates affect EDOT derivative activation and are expected to aid in optimizing the polymerization conditions for the preparation of high-molecular-weight conjugated polymers.展开更多
Three alternating conjugated polymers,namely PFTP,PCz TP,and PSi TP,which combine a thieno[3,4-b]pyrazine(TP)unit with different benzene-based donor units such as 9,9-dioctylfluorene,9-heptadecyl-9H-carbazole and 5,5-...Three alternating conjugated polymers,namely PFTP,PCz TP,and PSi TP,which combine a thieno[3,4-b]pyrazine(TP)unit with different benzene-based donor units such as 9,9-dioctylfluorene,9-heptadecyl-9H-carbazole and 5,5-dioctyl-5H-dibenzo[b,d]silole,were synthesized in good yield(>85%)and high molecular weight up to Mn=5.82×10^(4) via direct arylation polymerization(DAr P).All the resultant polymers exhibit moderate bandgap of about 1.80 e V and strong deep red/near-infrared emitting in the solid state.Among them,the PSi TP-based electroluminescence(EL)devices with an architecture of ITO/PEDOT:PSS/PTAA/emitting layer/TPBi/Li F/Al give the best performance with a maximum luminance of 2543 cd/m^(2) at 478 m A/cm^(2).This work expands the application scope of high-performance conjugated polymers which can be synthesized by DAr P.展开更多
Two novel heterocyclic diamine monomers: 1,2-dihydro-2-(4-aminophenyl)-4-[4-(4-aminophenoxy)phenyl] (2H)phthalazin-1-one and 1,2-dihydro-2-(4-aminophenyl)-4-[4-(4-aminophenoxy)-3,5-dimethylphenyl](2H)phthalazin-1-one ...Two novel heterocyclic diamine monomers: 1,2-dihydro-2-(4-aminophenyl)-4-[4-(4-aminophenoxy)phenyl] (2H)phthalazin-1-one and 1,2-dihydro-2-(4-aminophenyl)-4-[4-(4-aminophenoxy)-3,5-dimethylphenyl](2H)phthalazin-1-one were successfully synthesized from readily available heterocyclic bisphenol-like monomers in two steps in high yield. A series of novel poly(aryl ether amide)s containing the phthalazinone moiety were successfully prepared by the direct polymerization of the novel diamines and aromatic dicarboxylic acids using triphenyl phosphite and pyridine as condensing agents.展开更多
We study the free energy fluctuations for a mixture of directed polymers, which was first introduced by Borodin et al. （2015） to investigate the limiting distribution of a stationary Kaxdar-Parisi-Zhang （KPZ） equa...We study the free energy fluctuations for a mixture of directed polymers, which was first introduced by Borodin et al. （2015） to investigate the limiting distribution of a stationary Kaxdar-Parisi-Zhang （KPZ） equation. The main results consist of both the law of large numbers and the asymptotic fluctuation for the free energy as the model size tends to infinity. In particular, we find the explicit values （which may depend on model parameters） of normalizing constants in the fluctuation. This shows that such a mixture model is in the KPZ university class.展开更多
Two novel heterocylic diamine monomers: l,2-dihydro-2-(4-aminophenyl)-4-4-(4-aminophenoxy) phenyl]-(2H)-phthalazin-l-one and 1,2-Dihydro-2-( 4-aminophenyl )-4-[4-(4-aminophenoxy-3, 5-dimethylphenyl]-(2H)-phthalazin-1-...Two novel heterocylic diamine monomers: l,2-dihydro-2-(4-aminophenyl)-4-4-(4-aminophenoxy) phenyl]-(2H)-phthalazin-l-one and 1,2-Dihydro-2-( 4-aminophenyl )-4-[4-(4-aminophenoxy-3, 5-dimethylphenyl]-(2H)-phthalazin-1-one were successfully synthesized using readily available heterocyclic bisphenol-like monomers through two steps in high yield. A series of novel poly(aryl ether amide)s containing the phthalazinone moiety with inherent viscosities of 1.16–1.67 dL/g were prepared by the direct polymerization of the novel diamines and aromatic dicarboxylic acids using triphenyl phosphite and pyridine as condensing agents. The polymers were readily soluble in a variety of solvents such as N,N -dimethylformamide (DMF), N,N-dimethylacetamide (DMAc), dimethylsulfoxide ( DMSO ), N-methyl-2-pyrrolidinone (NMP), and pyridine. The polymers had high glass transition temperatures ( Tg) in the 291–329°C range.展开更多
基金supported by the National Natural Science Foundation of China(Grant Nos.52072105,21676067)the Key R&D Program of Anhui Province(202104a05020044)+2 种基金the Anhui Provincial Natural Science Foundation(2108085J23)Science and Technology Major Project of Anhui Province(202003a05020014)the Fundamental Research Funds for the Central Universities(PA2021KCPY0028,JZ2020YYPY0109).
文摘In traditional in situ polymerization preparation for solid-state electrolytes,initiators are directly added to the liquid precursor.In this article,a novel cellulose paper-based composite separator is fabricated,which employs alumina as the inorganic reinforcing material and is loaded with polymerization initiator aluminum trifluoromethanesulfonate.Based upon this,a separator-induced in situ directional polymerization technique is demonstrated,and the extra addition of initiators into liquid precursors is no longer required.The polymerization starts from the surface and interior of the separator and extends outward with the gradually dissolving of initiators into the precursor.Compared with its traditional counterpart,the separator-induced poly(1,3-dioxolane)electrolyte shows improved interfacial contact as well as appropriately mitigated polymerization rate,which are conducive to practical applications.Electrochemical measurement results show that the prepared poly(1,3-dioxolane)solid electrolyte possesses an oxidation potential up to 4.4 V and a high Li+transference number of 0.72.After 1000 cycles at 2 C rate(340 mA g^(−1)),the assembled Li||LiFePO_(4)solid battery possesses a 106.8 mAh g^(−1)discharge capacity retention and 83.5%capacity retention ratio,with high average Coulombic efficiency of 99.5%achieved.Our work may provide new ideas for the design and application of in situ polymerization technique for solid electrolytes and solid batteries.
文摘The influence of the electronic and steric properties of bromoaromatic substrates on direct arylation polymerization for synthesizing high-molecular-weight conjugated polymers was investigated through a combination of experiments and calculations.Bromo-aromatic substrates with electron-withdrawing fluoro substituents exhibited higher yields and degrees of polymerization under PPh3-assisted conditions compared to those with electron-donating or bulky methyl substituents.Additionally,excessive steric hindrance at ortho-sites or overly electrondeficient dibromoaromatic substrates leads to reaction inactivation.Calculations indicated that electron-withdrawing substituents enhanced the electrophilicity of arylpalladium-PPh3intermediates,facilitating the activation of electron-rich arylative substrates and promoting polymer growth.Furthermore,steric hindrance from the substituents can influence the preferred reaction pathway,thereby increasing the real reaction barriers.Both experimental and computational results suggest that bromoaromatic substrates with optimized electron-deficient characteristics significantly improve monomer conversion and polymerization efficiency with n-hexylmethylether-substituted EDOT.These findings clarify how the electronic and steric properties of bromo-aromatic substrates affect EDOT derivative activation and are expected to aid in optimizing the polymerization conditions for the preparation of high-molecular-weight conjugated polymers.
基金financially supported by the National Natural Science Foundation of China(Nos.21604063 and 52173010)the Program for Prominent Young College Teachers of Tianjin Educational Committee。
文摘Three alternating conjugated polymers,namely PFTP,PCz TP,and PSi TP,which combine a thieno[3,4-b]pyrazine(TP)unit with different benzene-based donor units such as 9,9-dioctylfluorene,9-heptadecyl-9H-carbazole and 5,5-dioctyl-5H-dibenzo[b,d]silole,were synthesized in good yield(>85%)and high molecular weight up to Mn=5.82×10^(4) via direct arylation polymerization(DAr P).All the resultant polymers exhibit moderate bandgap of about 1.80 e V and strong deep red/near-infrared emitting in the solid state.Among them,the PSi TP-based electroluminescence(EL)devices with an architecture of ITO/PEDOT:PSS/PTAA/emitting layer/TPBi/Li F/Al give the best performance with a maximum luminance of 2543 cd/m^(2) at 478 m A/cm^(2).This work expands the application scope of high-performance conjugated polymers which can be synthesized by DAr P.
文摘Two novel heterocyclic diamine monomers: 1,2-dihydro-2-(4-aminophenyl)-4-[4-(4-aminophenoxy)phenyl] (2H)phthalazin-1-one and 1,2-dihydro-2-(4-aminophenyl)-4-[4-(4-aminophenoxy)-3,5-dimethylphenyl](2H)phthalazin-1-one were successfully synthesized from readily available heterocyclic bisphenol-like monomers in two steps in high yield. A series of novel poly(aryl ether amide)s containing the phthalazinone moiety were successfully prepared by the direct polymerization of the novel diamines and aromatic dicarboxylic acids using triphenyl phosphite and pyridine as condensing agents.
基金supported by National Natural Science Foundation of China (Grant No. 11371317)the Fundamental Research Funds for the Central Universities
文摘We study the free energy fluctuations for a mixture of directed polymers, which was first introduced by Borodin et al. （2015） to investigate the limiting distribution of a stationary Kaxdar-Parisi-Zhang （KPZ） equation. The main results consist of both the law of large numbers and the asymptotic fluctuation for the free energy as the model size tends to infinity. In particular, we find the explicit values （which may depend on model parameters） of normalizing constants in the fluctuation. This shows that such a mixture model is in the KPZ university class.
基金Project (No. 59473019) supported by the National Natural Science Foundation of China.
文摘Two novel heterocylic diamine monomers: l,2-dihydro-2-(4-aminophenyl)-4-4-(4-aminophenoxy) phenyl]-(2H)-phthalazin-l-one and 1,2-Dihydro-2-( 4-aminophenyl )-4-[4-(4-aminophenoxy-3, 5-dimethylphenyl]-(2H)-phthalazin-1-one were successfully synthesized using readily available heterocyclic bisphenol-like monomers through two steps in high yield. A series of novel poly(aryl ether amide)s containing the phthalazinone moiety with inherent viscosities of 1.16–1.67 dL/g were prepared by the direct polymerization of the novel diamines and aromatic dicarboxylic acids using triphenyl phosphite and pyridine as condensing agents. The polymers were readily soluble in a variety of solvents such as N,N -dimethylformamide (DMF), N,N-dimethylacetamide (DMAc), dimethylsulfoxide ( DMSO ), N-methyl-2-pyrrolidinone (NMP), and pyridine. The polymers had high glass transition temperatures ( Tg) in the 291–329°C range.
