Electrochemicaldegradation of2,4-dichlorophenol （2,4-DCP） in aqueous solutionwas investigated over Ti/SnO2-Sb anode. The factors influencing thedegradation rate, such as applied currentdensity （2-40 mA/cm2 ）, pH ...Electrochemicaldegradation of2,4-dichlorophenol （2,4-DCP） in aqueous solutionwas investigated over Ti/SnO2-Sb anode. The factors influencing thedegradation rate, such as applied currentdensity （2-40 mA/cm2 ）, pH （3-11） and initial concentration （5-200 mg/L）were evaluated. Thedegradation of2,4-DCP followed apparent pseudo first-order kinetics. Thedegradation ratio on Ti/SnO2 -Sb anode attained 〉 99.9% after 20 min of electrolysis at initial 5-200 mg/L concentrations at a constant currentdensity of 30 mA/cm2 with a 10 mmol/L sodium sulphate （Na2SO4 ） supporting electrolyte solution. The results showed that 2,4-DCP （100 mg/L）degradation and total organic carbon （TOC） removal ratio achieved 99.9% and 92.8%, respectively, at the optimal conditions after 30 min electrolysis. Under this condition, thedegradation rate constant （k） and thedegradation half-life （t1/2 ）were 0.21 min1 and （2.8 ± 0.2） min, respectively. Mainly carboxylic acids （propanoic acid, maleic acid, propanedioic acid, acetic acid and oxalic acid） weredetected as intermediates. The energy efficiencies for2,4-DCPdegradation （5-200 mg/L）with Ti/SnO2-Sb anode ranged from 0.672 to 1.602 g/kWh. The Ti/SnO2-Sb anodewith a high activity to rapid organic oxidation could be employed todegrade chlorophenols, particularly2,4-DCP inwastewater.展开更多
A major challenge is to construct ceramic membranes with tunable structures and functions for water treatment.Herein,a novel corrosion-resistant polymer-derived silicon oxycarbide(SiOC)ceramic membrane with designed a...A major challenge is to construct ceramic membranes with tunable structures and functions for water treatment.Herein,a novel corrosion-resistant polymer-derived silicon oxycarbide(SiOC)ceramic membrane with designed architectures was fabricated by a phase separation method and was applied in organic removal via adsorption and oxidation for the first time.The pore structure of the as-prepared SiOC ceramic membranes was well controlled by changing the sintering temperature and polydimethylsiloxane content,leading to a pore size of 0.84–1.62μm and porosity of 25.0–43.8%.Corrosion resistance test results showed that the SiOC membranes sustained minimal damage during 24 h exposure to high-intensity acid–base conditions,which could be attributed to the chemical inertness of SiOC.With rhodamine 6G(R6G)as the model pollutant,the SiOC membrane demonstrated an initial eff ective removal rate of 99%via adsorption;however,the removal rate decreased as the system approached adsorption saturation.When peroxymonosulfate was added into the system,efficient and continuous degradation of R6G was observed throughout the entire period,indicating the potential of the as-prepared SiOC membrane in oxidation-related processes.Thus,this work provides new insights into the construction of novel polymer-derived ceramic membranes with well-defined structures and functions.展开更多
Quantitative structure-property relationship(QSPR)models were developed for prediction of photolysis half-life(t_(1/2))of polychlorinated biphenyls(PCBs)in water under ultraviolet(UV)radiation.Quantum chemical descrip...Quantitative structure-property relationship(QSPR)models were developed for prediction of photolysis half-life(t_(1/2))of polychlorinated biphenyls(PCBs)in water under ultraviolet(UV)radiation.Quantum chemical descriptors computed by the PM3 Hamiltonian software were used as independent variables.The cross-validated Q^(2)_(cum)value for the optimal QSPR model is 0.966,indicating good prediction capability for lg t_(1/2)values of PCBs in water.The QSPR results show that the largest negative atomic charge on a carbon atom(Q-C)and the standard heat of formation(ΔH_(f))have a dominant effect on t_(1/2)values of PCBs.Higher Q_(C)^(-)values or lowerΔHf values of the PCBs leads to higher lg t_(1/2)values.In addition,the lg t_(1/2)values of PCBs increase with the increase in the energy of the highest occupied molecular orbital values.Increasing the largest positive atomic charge on a chlorine atom and the most positive net atomic charge on a hydrogen atom in PCBs leads to the decrease of lg t_(1/2)values.展开更多
基金supported by the National Science Foundation for Innovative Research Group of China(No.51121003)the Specialized Research Fund for the Doctoral Program of Higher Education of China(No.20110003110023)the special fund of State Key Joint Laboratory of Environment Simulation and Pollution Control of China
文摘Electrochemicaldegradation of2,4-dichlorophenol （2,4-DCP） in aqueous solutionwas investigated over Ti/SnO2-Sb anode. The factors influencing thedegradation rate, such as applied currentdensity （2-40 mA/cm2 ）, pH （3-11） and initial concentration （5-200 mg/L）were evaluated. Thedegradation of2,4-DCP followed apparent pseudo first-order kinetics. Thedegradation ratio on Ti/SnO2 -Sb anode attained 〉 99.9% after 20 min of electrolysis at initial 5-200 mg/L concentrations at a constant currentdensity of 30 mA/cm2 with a 10 mmol/L sodium sulphate （Na2SO4 ） supporting electrolyte solution. The results showed that 2,4-DCP （100 mg/L）degradation and total organic carbon （TOC） removal ratio achieved 99.9% and 92.8%, respectively, at the optimal conditions after 30 min electrolysis. Under this condition, thedegradation rate constant （k） and thedegradation half-life （t1/2 ）were 0.21 min1 and （2.8 ± 0.2） min, respectively. Mainly carboxylic acids （propanoic acid, maleic acid, propanedioic acid, acetic acid and oxalic acid） weredetected as intermediates. The energy efficiencies for2,4-DCPdegradation （5-200 mg/L）with Ti/SnO2-Sb anode ranged from 0.672 to 1.602 g/kWh. The Ti/SnO2-Sb anodewith a high activity to rapid organic oxidation could be employed todegrade chlorophenols, particularly2,4-DCP inwastewater.
基金supported by the National Key R&D Program of China(Grant No.2021YFB3200500)Natural Science Foundation of China(Grant No.52370014)+2 种基金Ningbo 3315 plan(Grant No.2018A-03-A)Natural Science Foundation of Tianjin City(Grant No.63241631)the financial support of Joint Lab for Advanced Organosilicon Precursors with Zhejiang Xinshichen New Materials Ltd.Co.
文摘A major challenge is to construct ceramic membranes with tunable structures and functions for water treatment.Herein,a novel corrosion-resistant polymer-derived silicon oxycarbide(SiOC)ceramic membrane with designed architectures was fabricated by a phase separation method and was applied in organic removal via adsorption and oxidation for the first time.The pore structure of the as-prepared SiOC ceramic membranes was well controlled by changing the sintering temperature and polydimethylsiloxane content,leading to a pore size of 0.84–1.62μm and porosity of 25.0–43.8%.Corrosion resistance test results showed that the SiOC membranes sustained minimal damage during 24 h exposure to high-intensity acid–base conditions,which could be attributed to the chemical inertness of SiOC.With rhodamine 6G(R6G)as the model pollutant,the SiOC membrane demonstrated an initial eff ective removal rate of 99%via adsorption;however,the removal rate decreased as the system approached adsorption saturation.When peroxymonosulfate was added into the system,efficient and continuous degradation of R6G was observed throughout the entire period,indicating the potential of the as-prepared SiOC membrane in oxidation-related processes.Thus,this work provides new insights into the construction of novel polymer-derived ceramic membranes with well-defined structures and functions.
基金The research was supported by the Open Foundation of the State Key Laboratory of Hydrology-Water Resources and Hydraulic Engineering(No.2009490511)the special fund of State Key Joint Laboratory of Environment Simulation and Pollution Control(No.10Y08ESPCN)the National High Technology Research and Development Program of China(No.2009AA05Z306).
文摘Quantitative structure-property relationship(QSPR)models were developed for prediction of photolysis half-life(t_(1/2))of polychlorinated biphenyls(PCBs)in water under ultraviolet(UV)radiation.Quantum chemical descriptors computed by the PM3 Hamiltonian software were used as independent variables.The cross-validated Q^(2)_(cum)value for the optimal QSPR model is 0.966,indicating good prediction capability for lg t_(1/2)values of PCBs in water.The QSPR results show that the largest negative atomic charge on a carbon atom(Q-C)and the standard heat of formation(ΔH_(f))have a dominant effect on t_(1/2)values of PCBs.Higher Q_(C)^(-)values or lowerΔHf values of the PCBs leads to higher lg t_(1/2)values.In addition,the lg t_(1/2)values of PCBs increase with the increase in the energy of the highest occupied molecular orbital values.Increasing the largest positive atomic charge on a chlorine atom and the most positive net atomic charge on a hydrogen atom in PCBs leads to the decrease of lg t_(1/2)values.
