SmCo based films with excellent intrinsic magnetic properties have promising applications in micro-electro-mechanical system(MEMS).However,due to the complexity of phase composition and uncontrollable crystallization ...SmCo based films with excellent intrinsic magnetic properties have promising applications in micro-electro-mechanical system(MEMS).However,due to the complexity of phase composition and uncontrollable crystallization degree of SmCo hard magnetic phase in the film,both the coercivity(Hc)and remanence(Mr)of films are difficult to enhance simultaneously.In this paper,SmCo based films were deposited with a Cr underlayer and capping layer on single crystal Si substrates via magnetron sputtering process.The effects of annealing parameters and Sm/Co atomic ratio on the phase structure and coercivity of films are discussed.By adjusting the Sm/Co atomic ratio from 1:5 to 1:4,Co soft magnetic phase disappears and the single phase SmCo5 is obtained,leading to the increase of coercivity of the films from 30 to 34 kOe.The influence of deposition temperature and Cu doping on magnetic properties of SmCo based films was investigated.When the deposition temperature increases from room temperature to 250℃,the coercivity will further increase from 34 to 51 kOe.However,a severe kink is observed in the demagnetization curves due to the poor exchanged coupling.An analysis of transmission electron microscopy(TEM)confirms that the average size of non-hard magnetic amorphous phase exceeds the effective exchanged coupling length of SmCo5,which contributes to the decoupling and low remanence ratio.Therefore,doping Cu and applying a post-annealing process can significantly improve the crystallization degree of the films.Both the coercivity and the remanence ratio of the demagnetization curves are greatly enhanced.We propose a plausible strategy to prepare the SmCo based films with high coercivity and remanence ratio by temperature and chemical optimization,which can be utilized in high performed MEMS devices.展开更多
Plastic waste is causing serious environmental problems. Developing efficient, cheap and stable catalytic routes to convert plastic waste into valuable products is of great importance for sustainable development, but ...Plastic waste is causing serious environmental problems. Developing efficient, cheap and stable catalytic routes to convert plastic waste into valuable products is of great importance for sustainable development, but remains to be a challenging task. Zeolites are cheap and stable, but they are usually not efficient for plastic conversion at a low temperature. Herein a series of microporous and mesoporous zeolites were used to study the influence of porosity and acidity of zeolite on catalytic activity for plastics conversion. It was observed that H-Beta zeolite was an efficient catalyst for cracking high-density polyethylene to gasoline at 240℃, and the products were almost C_(4)–C_(12) alkanes. The effect of porosity and acidity on catalytic performance of zeolites was evaluated, which clearly visualized the good performance of H-Beta due to high surface area, large channel system, large amount accessible acidic sites. This study provides very useful information for designing zeolites for efficient conversion of plastics.展开更多
基金Project supported by the National Key R&D Program of China(2022YFB3505700,2022YFB3807900)National Natural Science Foundation of China(51901079)+2 种基金R&D(Research and Development)Plan in Key Areas of Guangdong Province(SDZX2021002,212021032611700001)Natural Science Foundation of Guangdong Province(2020A1515010736,2021A1515010451)the Guangzhou Municipal Science and Technology Program(202007020008)。
文摘SmCo based films with excellent intrinsic magnetic properties have promising applications in micro-electro-mechanical system(MEMS).However,due to the complexity of phase composition and uncontrollable crystallization degree of SmCo hard magnetic phase in the film,both the coercivity(Hc)and remanence(Mr)of films are difficult to enhance simultaneously.In this paper,SmCo based films were deposited with a Cr underlayer and capping layer on single crystal Si substrates via magnetron sputtering process.The effects of annealing parameters and Sm/Co atomic ratio on the phase structure and coercivity of films are discussed.By adjusting the Sm/Co atomic ratio from 1:5 to 1:4,Co soft magnetic phase disappears and the single phase SmCo5 is obtained,leading to the increase of coercivity of the films from 30 to 34 kOe.The influence of deposition temperature and Cu doping on magnetic properties of SmCo based films was investigated.When the deposition temperature increases from room temperature to 250℃,the coercivity will further increase from 34 to 51 kOe.However,a severe kink is observed in the demagnetization curves due to the poor exchanged coupling.An analysis of transmission electron microscopy(TEM)confirms that the average size of non-hard magnetic amorphous phase exceeds the effective exchanged coupling length of SmCo5,which contributes to the decoupling and low remanence ratio.Therefore,doping Cu and applying a post-annealing process can significantly improve the crystallization degree of the films.Both the coercivity and the remanence ratio of the demagnetization curves are greatly enhanced.We propose a plausible strategy to prepare the SmCo based films with high coercivity and remanence ratio by temperature and chemical optimization,which can be utilized in high performed MEMS devices.
基金the National Natural Science Foundation of China(Grant Nos.22293015,22293012,and 22121002)the Research Funds of Happiness Flower ECNU(2020ST2203).
文摘Plastic waste is causing serious environmental problems. Developing efficient, cheap and stable catalytic routes to convert plastic waste into valuable products is of great importance for sustainable development, but remains to be a challenging task. Zeolites are cheap and stable, but they are usually not efficient for plastic conversion at a low temperature. Herein a series of microporous and mesoporous zeolites were used to study the influence of porosity and acidity of zeolite on catalytic activity for plastics conversion. It was observed that H-Beta zeolite was an efficient catalyst for cracking high-density polyethylene to gasoline at 240℃, and the products were almost C_(4)–C_(12) alkanes. The effect of porosity and acidity on catalytic performance of zeolites was evaluated, which clearly visualized the good performance of H-Beta due to high surface area, large channel system, large amount accessible acidic sites. This study provides very useful information for designing zeolites for efficient conversion of plastics.
